User manual BOSCH WKD24360EE

[. . . ] Washer-dryer en Installation and operating instructions Table of contents Operating instructions General safety information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Environmental protection/economy tips . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Your new washer-dryer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Before washing for the first time . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Descaling the drum: ­ Only use a proprietary brand of descaler with corrosion inhibitor for washing machines for descaling the washer-dryer. ­ Observe the manufacturer's instructions regarding use and dosage. ­ After descaling and removing rust from the drum, run the ' + B (Rinse + Spin) programme several times to remove any remaining acid. coins, paper clips, needles, nails) have caused rust spots: ­ Use a chlorine-free cleaning agent; observe the manufacturer's instructions. Never use steel wool. Detergent drawer If there are detergent or care product residues: Pull out the detergent drawer as far as the stop. Press on the zone labelled PUSH and take out the detergent drawer. Clean the detergent drawer guide in the washer-dryer. Remove the fabric softener compartment insert. Clean the detergent drawer and fabric softener compartment insert under running water. Insert the fabric softener compartment insert. Insert the detergent drawer. 17 Drain pump Turn the programme selector to Stop (Off). Use a screwdriver to release the lock pins. Tip the kick panel and pull upwards to remove. Draining the water Take the drain hose out of the retainer. Remove the plug from the drain hose and release the washing water. ­ The container for the drained water may have to be emptied several times. ­ When no more water runs out, replace the plug. Place the drain hose into the retainer. Cleaning the drain pump Unscrew the pump cover. ­ Clean the pump housing and remove any foreign objects. ­ Make sure that the impeller can turn freely. Replace the pump cover and screw firmly in place. Place the kick panel in the 4 clip-in slots and secure to the housing using the lock pins. Filter in the water supply hose If no water runs into the washer-dryer, or only an insufficient amount, you must first reduce the water pressure in the supply hose: Turn off the tap. Choose any programme (except '+B (Rinse + Spin) / (Empty + Spin). [. . . ] 29 Transport safety bolts . . . . . . . . . . . . . 24 Housing Pre-wash -Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 -Display . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Prewash . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Unbalanced load detection Programme -Cancelling . . . . . . . . . . . . . . . . . . . . . . . . . 14 system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 -Changing . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]