User manual BOSCH WTL6101EU

[. . . ] WTL 6101 en Instruction Manual and Installation Instructions Table of Contents Operating Instructions Your new dryer . Notes on environmental protection/economical drying . Environmentally-friendly and economical drying . 4 5 5 5 6 6 6 7 7 7 8 8 9 9 10 11 12 13 13 13 14 15 15 15 16 17 17 18 18 18 2 Cleaning and care . [. . . ] Push the container back in until it engages. Emptying The container may also be emptied during the drying cycle. It is not necessary to switch off the dryer. If the Water p" indicator lamp lights up while the dryer is running, the container must be emptied within 90 minutes. After 90 minutes have passed, the status indicator will display End", but the laundry will not be dry. Empty the container and then push it back in. The programme starts again from the beginning. 21 Cleaning the condenser unit The condenser unit should be cleaned three or four times a year, or more often if the dryer is used very frequently. Residual water may leak out so place an absor bent towel underneath the maintenance flap. Turn both locking levers towards each another (in the direction of the arrows). Pull out the condenser unit. dTake care not to damage the condenser unit. Only use water to clean the condenser unit. Clean the condenser unit thoroughly and let all the water drain off. Push the condenser unit back in, the handle must be at the bottom. 10. Clean fluff and other dirt from the maintenance flap seal. 11. Press the maintenance flap evenly on the right and left until it engages in place. i The door will only close if the maintenance flap is properly closed. 22 What to do if . . . dDanger, electrical current. Repairs must only be carried out by the after sales service or an authorised expert. If you cannot rectify a fault yourself, or a repair is ne cessary: q Turn the programme selector to Off. q Contact the after sales service (see page 26). What to do if . . . The Mu" indicator M lamp does not come on. Cause The dryer is not plugged in. The door and/or maintenance flap are not closed properly. The ambient temperature is below 5 ºC. Solution Plug in the dryer. Close the maintenance flap and the door. Select the programme you require using the programme selector. [. . . ] They could other wise be overtightened. dDo not use a power screwdriver. To remove the door: !Undo the screw for the bottom door hinge. 2. Hold the door firmly and unscrew the top door hin ge. Pull the door and the hinge outwards to the front. [. . . ]