User manual BOSCH WTL6305GB

[. . . ] WTL 6305 en Instruction Manual and Installation Instructions Table of Contents Operating Instructions Your new dryer . Notes on environmental protection/economical drying . Environmentally-friendly and economical drying . 4 5 5 5 6 6 6 7 7 7 8 8 9 9 10 11 12 13 13 13 14 15 15 15 16 17 17 18 18 18 18 2 End of the programme . [. . . ] It is not necessary to switch off the dryer. water" indicator lamp lights up and a buzzer sounds while the dryer is running, the contai ner must be emptied within 90 minutes. The buzzer stops automatically after approximately two minutes. After 90 minutes have passed, the status indicator will display anti crease/End", but the laundry will not be dry. Empty the container and then push it back in. The programme starts again from the beginning. 22 Cleaning the condenser unit The condenser unit should be cleaned three or four times a year, or more often if the dryer is used very frequently. Residual water may leak out so place an absor bent towel underneath the maintenance flap. Fully fold down the maintenance flap. 5. Turn both locking levers towards each another (in the direction of the arrows). Pull out the condenser unit. dTake care not to damage the condenser unit. Only use water to clean the condenser unit. Clean the condenser unit thoroughly and let all the water drain off. Push the condenser unit back in, the handle must be at the bottom. 10. Clean fluff and other dirt from the maintenance flap seal. 11. Press the maintenance flap evenly on the right and left until it engages in place. i The door will only close if the maintenance flap is properly closed. 23 Changing the bulb for the interior light You will need a special tool and a new bulb. The se are both available from specialist suppliers. - 15 watt bulb for E14 oven. dDanger of death Danger of death from electrical voltage. Open the door, let the dryer cool down (if necessa ry). The arrow indicates the position of the bulb. 2. Undo the light cover bolt in the direction of the ar row. Fold out the light cover through 90º. If the co ver is stuck, insert a flat tool (e. g. [. . . ] They could other wise be overtightened. dDo not use a power screwdriver. To remove the door: !Undo the screw for the bottom door hinge. 2. Hold the door firmly and unscrew the top door hin ge. Pull the door and the hinge outwards to the front. [. . . ]