User manual BOSCH WTR85VS8SN

[. . . ] Disconnect the power supply before opening the appliance. Immediately shut off the cold water supply to the appliance should it leak. The statutory regulations of the respective country, as well as those of the local electricity and water suppliers, must be adhered to. The continuous-flow heater is a Class I appliance and must be connected to the protective earth. [. . . ] the illustrations Can be found in the centre of the instruction manual. Unpack the appliance and check for transport damage. if any compo- Nents are damaged, then do not connect the appliance. Please dispose of the packaging and the old appliance in an environmentally-friendly manner. When removing the cover, please note the following: The cover is fastened by a central closure behind the service flap. The supplied water connection nozzles must be installed!Must be disconnected from the power supply. Unscrew the fuse or switch off the circuit breaker. Install the water connection nozzles according to the instructions on the supplementary sheet. The electrical connection cable can either be guided in at the top (X) or bottom (Y). The rear panel must lie against the cold water connection nozzle in the position provided for such (Fig. The appliance must not tilt out more than 1° (2 %) in any direction!The grommet must tightly surround the connection cable. if it is da- Maged during mounting, the openings must be provided with watertight sealing. The electrical supply terminal can be fitted at the top (X) or bottom (Y). The sheath of the connection cable must extend for at least 40 mm into the appliance. You can compensate for any unevenness of the wall's surface. With a distance to the wall of 8­16 mm, insert the spacer and install the extender (Fig. The appliance must be mounted securely on the wall. If necessary, attach it at the lower adjustable screws (Fig. Before connecting the water, guide the AquaStop connection pipe The grommet must tightly surround the connection pipe. Connect the water supply, then open the cold water supply. [. . . ] If the cold water supply exceeds a temperature of 55 °C, the water will not be warmed any further. Important: The cold water supply temperature must not be higher than 55 °C!If the cold water supply exceeds a temperature of 60 °C, a circuit breaker will trigger and shut the appliance off. Therefore, the residential plumbing must be equipped with a thermostatic premixer (e. [. . . ]