User manual BOSCH WVD24460GB

[. . . ] Wash + Dry Avantixx en Operating and Installation Instructions Please read the operating and installation instruction supplied and handle the appliance accordingly. Table of Contents Operating instructions Information concerning waste disposal . 4 Protection of the environment / hints and tips . 7 Before using your washer-dryer for the first time . 12 Preparing, sorting and loading the laundry . [. . . ] ² The laundry can be topped up at any time during the finish in time. Close the washer-dryer door. 33 Childproof lock You can secure your washer-dryer to prevent selected functions from being inadvertently changed. If the childproof lock has been selected: – no changes can be made while the programme is running, – the symbol @ flashes if a programme setting is inadvertently changed, – should the appliance be switched off and on while a programme is running, the programme will continue at the point at which it was interrupted, – when the programme ends, the duration time is showed as 0:01, the loading door cannot be opened, deactivate the childproof lock, the door can be opened while the display shows -0-. Activating the childproof lock ■ Set the programme selector to the required programme and, if required, select other settings. Load the laundry and close the loading door. The programme starts. ■ ■ ² Release the Start/Pause A button. Example of Easy-Care 40 °C programme: ■ Touch the 5 button and hold down (for approx. 5 seconds) until the @ symbol is displayed. Release the 5 button, the childproof lock is activated, the symbol is permanently on. ■ 5sec. Deactivating the childproof lock The childproof lock should be deactivated before making programme changes or ending programmes at selected programme. When a different programme has been selected, the @ symbol will continue to flash and the childproof lock can be deactivated. But the running programme will be terminated and return to ready state. ■ Touch the 5 button and hold down (for approx. 5 seconds) until the @ symbol goes out. ² If there is a power failure, the childproof lock remains on. 34 Signal The acoustic signal indicates: – that the additional functions (buttons) have been switched on or off. – individual programmes statuses (e. g. start of programme, end of programme), operating errors and faults. Start the signal mode 1. One step to right Set volume for. . . 5. release and find the number from 0 to 4 6. Information signals* ■ After setting, run the programme selector to “Off”, the volume of signal is stored * If required, set repeatedly. 35 During washing/drying Changing the programme If you have accidentally selected the wrong programme ■ If the childproof lock is active, temporarily deactivate, see page 34. Turn the programme selector to a newly selected programme. If required, re-activate the childproof lock, see page 34. ■ ■ ■ Cancelling the programme If you would like to terminate a programme and remove the laundry: ■ If the childproof lock is active, deactivate, see page 34. Turn the programme selector to Drain [, Spin Í or Rinse '. If required, select the desired spin speed (but not setting “$” (without final spin)). ■ ² If a programme is interrupted at a high temperature, Rinse ' should be selected to cool down the laundry. ■ For drying programme, select time-dry 15 min cooling programm to cool down the laundry. If required, switch on the childproof lock again. Turn the programme selector to Off. ■ ■ ■ ■ ■ 36 ■ ■ Open the washer-dryer door. Remove the laundry. ² If a programme was interrupted at a high temperature, such as drying programme, please do no open the washer-dryer door until the appliance has cooled down. Pausing the programme If you would like to pause a runing programme without changing the sequence: ■ Touch the Start/Pause A button during washing cycle, the display shows "PAUS" (pause), if door open symbol } flashes at this moment means the door can be opened after 1 minute later, when the } symbol and "OPEn" come on, open the door if required, add/remove the laundry, close the door. [. . . ] When the water is being pumped out of the washer-dryer, check that the water drains away quickly enough. ■ Aligning the washerdryer All four appliance feet must be firmly on the ground. Level the washer-dryer with the assistance of the four adjustable feet and a spirit level: ■ ■ ■ Loosen the lock nut 1 using the wrench. Adjust the height by rotating the foot 2. Tighten the lock nut 1 against the housing. 59 Connecting the power Caution Connect the washer-dryer only to an alternating current via a correctly installed earthed socket. [. . . ]