User manual BOSCH WVD245S3GB

[. . . ] Exxcel en Operating and Installation Instructions Table of Contents Operating instructions Information concerning waste disposal . Protection of the environment / hints and tips . Before using your washer dryer for the first time . Preparing, sorting and loading the laundry . [. . . ] The symbols for the running programme sections appears. 30 Washing/drying with individual settings You can adjust the settings to your requirements. First find a quick overview of the adjustable settings. The steps for changing the settings are described in detail overleaf. Overview at a glance Turn on the tap, load the laundry and close the loading door. Add correct amout of detergent, additives. Select desired washing/drying programme with programme selector. Temp. * Page 32 or cold wash Spin speed* Page 32 or rinse hold Finish in time* Page 33 can be set in 1-hour steps Signal* Page 36 on off loudness Make further settings or touch the Start/Pause M button. Childproof lock** Page 35 on off * Individual settings can be combined. **This function is recommended to avoid misoperation by casual touching. 31 Washing temperature You can change the default washing temperature. q Keep touching the temperature button until the desired temperature displays. Temp. i For different clothing, there are different programmes with respective temperature ranges. Spin speed You can change the default spin speed. q Touch the B Spin button until desired spin speed displays. i If setting (without final spin) has been selected, the washing remains in the final rinsing water. Before the laundry can be uplaoded, the Drain b or Spin B programme must be performed. Touch Spin B button to select the desired spin speed or touch the Start/Pause" button directly to start subsequent spin cycle with default spin speed. i The speed can be changed at any time by touching the Spin B button until the new speed is displayed. Setting "" (without final spin) is possible until the Rinse programme section starts. 32 Finish in time Example of Easy Care 40 ºC programme: Before a programme starts, you can specify by how many hours later the programme is to be ended. q Touch the W button, the display shows the minimum finish in time of the selected programme. i The minimum finish in time of different programmes are different. It depends on the duration of selected programme. q Touch the W button until the desired number of hours is displayed. i The finish in time can be set in 1 hour steps. The time can be delayed up to a maximum of 24h. If a finish in time of 24h has been set, the programme duration mode can be accessed by touching the W button again. You can change other settings or q Touch the Start/Pause M button. The finish in time starts counting down. [. . . ] Level the washer dryer with the assistance of the four adjustable feet and a spirit level: q Loosen the lock nut 1 using the wrench. q Adjust the height by rotating the foot 2. q Tighten the lock nut 1 against the housing. 61 Connecting the power Caution Connect the washer dryer only to an alternating current via a correctly installed earthed socket. The mains voltage must correspond to the voltage specification on the washer dryer (nameplate). [. . . ]