User manual BOSE 151 SE ENVIRONMENTAL SPEAKERS

[. . . ] If you are unsure of your ability to complete this installation, consult a professional installer. Hereby Bose B. V. declares that this equipment is compliant with the essential requirements of the EMC Directive 89/336/EEC. This equipment is intended for use (amongst others) in all EC/EFTA countries. The complete declaration of conformity can be found on <http://www. bose. com/guides>. ©2004 Bose Corporation. [. . . ] Refer to "Required tools and materials" on page 3. Note: If you plan to feed the speaker cord through the bracket, feed the cord through the wall before mounting the bracket. Mount bracket part A to the wall using the appropriate hardware for wood (G) or concrete (H and G). Make sure the hole for the bracket locking screw is on your left (Figure 4). Mount bracket part B to the rear of the speaker using two machine screws E and two lock washers F (Figure 4). 4 The Bose® 151® SE Environmental Speakers 6. Secure the speaker with bracket part B to bracket part A using bracket locking screw C and lock washer D (Figure 3). To adjust the angle, loosen screw C slightly (Figure 5), move the speaker up or down, and retighten screw C. Figure 5 Adjusting speaker angle English C Note: Your 151® SE speakers can be mounted vertically. However, when mounted vertically you will not experience Stereo Everywhere® speaker performance. Note: For vertical mounting, mount bracket part A so that the hole for bracket locking screw C is at the lower end of the bracket. When mounted vertically, you can rotate the logo to be read horizontally. Gently pull out on the logo, rotate it into position and release. Connecting your speakers to your receiver/amplifier Speaker cord consists of two insulated wires. The wire marked with a stripe or rib is used for the positive (+) red terminal connection. The plain wire is used for the negative (­) black terminal connection. Strip approximately ½ inch (1. 3 cm) of insulation from the ends of both wires (Figure 6). Then, twist the ends of each wire so there are no loose strands. CAUTION: Before making any connections, turn off your receiver/amplifier and unplug it from the AC power outlet. Figure 6 Speaker wiring ½ inch (1. 3 cm) (+) Wire Rear of speaker (+) Terminal 1. At the back of your speaker (Figure 6), unscrew the hex knobs on the terminal posts until you can see the small hole going through each post. Insert the marked (+) wire into the red (+) terminal. Insert the plain (­) wire into the black (­) terminal. Check the speaker connections carefully. [. . . ] If the speaker now works, the original speaker cord is bad. If the speaker still does not work, the speaker is bad. If trouble persists, contact your authorized Bose dealer, who will arrange for service. Refer to the list of phone numbers and addresses included in the carton. 6 The Bose® 151® SE Environmental Speakers Cleaning your speakers Use a cloth dampened in mild detergent and water to remove dust or dirt from the outside of your 151® SE speakers. [. . . ]