User manual BOSE 301 V

[. . . ] CAUTION: To avoid danger of suffocation, keep the plastic bags that wrap these speakers out of the reach of children. Figure 1 What comes in the carton 201® series V speakers 301® series V speakers For your records Serial numbers are located on the back of each speaker. Serial number: _____________________ and _____________________________ Dealer name: _________________________________________________________ Dealer phone: _____________________ Purchase date ____________________ We suggest you keep your sales slip and warranty card together with this owner's guide. 3 AM264981_01 _V. pdf · August 13, 2002 Setting Up Select the locations for your 201® or 301® speakers Bose® 201 and 301 speakers are designed to fit horizontally on a stable and level table or shelf (Figure 2). [. . . ] Inspect both wires carefully. 5 AM264981_01 _V. pdf · August 13, 2002 Setting Up Make the connections Just press the terminal tab on the back of each speaker to insert the appropriate wire (Figure 3). CAUTION: Before making any connections, turn off your receiver and unplug it from the AC power (mains) outlet. Not doing so may result in damage to your system. CAUTION: Never use broken or frayed wiring, which can result in electrical shock or damage. Connect one speaker cord to your right speaker. · Attach each marked wire (+) to the appropriate (+) terminal. · Attach each plain wire (­) to the appropriate (­) terminal. Connect the other end of the same cord to the RIGHT SPEAKER OUTPUT of your receiver. · Attach each marked wire (+) to the appropriate (+) terminal. · Attach each plain wire (­) to the appropriate (­) terminal. Figure 3 How to make terminal connections Connect the second cord to the left speaker and LEFT SPEAKER OUTPUT. Black Red + -- -- Red Black + + -- 301® series V 201® series V Test the speakers To make sure your speakers operate correctly: 1. Set the receiver to MONO (monophonic), if that is an option on your receiver. Make sure that all special effects (such as surround sound) are turned off. Set the balance control to normal (center position). Play some deep bass passages of music through the speaker. The sound should seem to come from a point between the two speakers. If it is not, one of the connections may be reversed, causing the speakers to play out of phase (refer to "Make the connections" above). To correct the problem, make sure all the wires are connected positive to positive (+ to +) and negative to negative (­ to ­). [. . . ] · Follow the same procedure for the problem of no sound from one speaker, as outlined above. One speaker sounds distorted Not enough bass or treble · Adjust the bass and treble controls on the receiver. · Check the connections to make sure they are correctly in phase (+ to + and ­ to ­). Refer to "Make the connections" on page 6. [. . . ]