User manual BOSE ACOUSTIC WAVE CONNECT KIT FOR IPOD

[. . . ] A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wider blade or third prong are provided for your safety. If the provided plug does not fit in your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] It is neither designed nor tested for use Note: This product is intended to be used only with the power supply provided. CAUTION: Long-term exposure to loud music may cause hearing damage. To avoid extreme volume when using headphones, especially for extended periods. Power Pack only (left) or Power pack with line cord (right) This kit is fully compatible with most iPod models. For the Acoustic Wave® connect kit to work as expected, your iPod must have the latest version of iPod software installed. If you need to upgrade, simply visit the Apple iPod website and follow the instructions there. We recommend that you place the dock to the right of your Acoustic Wave music system II so that your iPod has minimal effect on FM or AM reception. Be sure the IR sensor on the front of the iPod dock is visible and aligned with the Acoustic Wave system IR sensor so both products respond to the remote. Please be sure to make all other connections before plugging these products into a power outlet. Connect the dock to the Acoustic Wave music system II (as shown below) or to the Acoustic Wave Music system with CD changer (as shown on page 5). Acoustic Wave® music system II with CD changer Connect the free end of the power pack cable to the dock. Plug the power pack into an AC (mains) outlet. We recommend replacing the remote that came with your Acoustic Wave® II system with this new remote (shown below). Then you can use the new remote exclusively (not the buttons on your Acoustic Wave® II system), to keep your iPod and system performing together as intended. Note: The remote that came with your Acoustic Wave® system can also be used to control the iPod kit. Use the AUX button on the original remote instead of the iPod button on the new remote. Most of the remote control buttons are described in your Acoustic Wave® II system owner's guide. The response to some remote commands depends on which source (FM/AM/ CD/iPod/AUX) is playing. If the remote does not work as you expect, press the button for that source to reset the intended mode of operation. To hear your iPod play, you may need to press the AUX 1-2 button to select the input used to connect the dock. Insert your iPod firmly into the dock and make sure it is securely seated in the dock adapter. Your iPod turns on in a paused state and begins charging, as needed. [. . . ] Be sure the audio cable from the dock is connected to INPUT AUX 1 on the changer. press iPod and check to see that AUX 1 appears on the CD changer display. The Bose® system speakers play even when headphones are plugged into the docked the iPod. This silences the system so the sound plays through the headphones only. [. . . ]