User manual BOSE ACOUSTIC WAVE MUSIC SYSTEM II 5-CD CHANGER

[. . . ] Please take the time to follow the instructions in this owner's guide carefully. It will help you set up and operate your system properly and enjoy all of its advanced features. Please save this owner's guide for future reference. WARNING: To reduce the risk of fire or electrical shock, do not expose the product to rain or moisture. [. . . ] WARNING: To avoid danger of suffocation, keep the plastic bags out of the reach of children. Now is a good time to record the serial number of your Acoustic Wave® II CD changer here and on your product registration card. The serial number is located on the back panel. Serial number: _____________________________ Purchase date: _________________________________________ We suggest you keep your sales receipt and a copy of your product registration card together with this owner's guide. English The Acoustic Wave® II CD changer is designed to fit under your Acoustic Wave® music system II. Before you connect the two, however, select a good location for the stacked units. When choosing the location, remember that the tonal quality of your Acoustic Wave® music system II, as with any high-performance sound system, will vary with room placement. Feel free to try different locations, but keep the following guidelines in mind: · The Acoustic Wave® music system II is designed to sound best when placed on a shelf, counter, desk, or table top, 30 to 48 inches (75 to 120 cm) from the floor. The CD player in the Acoustic Wave® music system II needs an allowance of several inches for the CD cover on top of the music system to open. The Acoustic Wave® music system II should be near the center of a wall and 6 inches (15 cm), or less, away from the wall. To increase the bass response, move the unit toward any corner of the room; to decrease bass response, move it away from the corner. Seating your Acoustic Wave® music system II on the CD changer With the CD changer in your chosen location, carefully set your Acoustic Wave® music system II on top of the CD changer (Figure 2a). Make sure the Acoustic Wave® music system II fits onto the raised guides on top of the CD changer. Make sure the Acoustic Wave® music system II sits flat and the side edges of both units are aligned. Make sure there is a clear optical path in front of the unit to allow the infrared emitters and receivers to communicate (Figure 2b). English Before you start this setup procedure, disconnect the AC power cord on your Acoustic Wave® music system II and set it aside. You will need to use it again in Step 3. On the back of the CD changer there are two cables that connect to your Acoustic Wave® music system II. Español Insert the two connectors of the AUX input cable into AUX IN jacks on the back of the music system (Figure 3). Be sure to match the colors of the connectors and jacks: red to red, and white to white. Plug the attached CD changer power cord into the AC power jack on the back of the music system. Plug the small end of the power cord into the power jack on the back of the CD changer. [. . . ] Make sure the two RCA connectors are firmly inserted, red to red, and white to white, into the AUX IN jacks on the Acoustic Wave® music system II. Make sure nothing is blocking or preventing the IR signals emitted by the CD changer from reaching the receiver on the front of the Acoustic Wave® music system II. Make sure the system is in a location where it cannot get bumped. If so, move it to a more protected location. [. . . ]