User manual BOSE ACOUSTIMASS 5 IV POWERED SPEAKER SYSTEM

[. . . ] The Bose® Acoustimass® 5 and 20 Powered Speaker System Owner's Guide Safety/Maintenance Information English WARNING: To reduce the risk of fire or electric shock, do not expose the system to rain or moisture. CAUTION RISK OF ELECTRICAL SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED PERSONNEL. AVIS RISQUE DE CHOC ÉLECTRIQUE NE PAS OUVRIR AFIN DE PRÉVENIR UN CHOC ÉLECTRIQUE NE PAS ENLEVER LE COUVERCLE ARRIÈRE. IL NE SE TROUVE À L'INTÉRIEUR AUCUNE PIÈCE POUVANT ÊTRE RÉPARÉE PAR L'USAGER. S'ADRESSER À UN RÉPARATEUR COMPÉTENT. These CAUTION marks are located on the bottom of your Lifestyle® Acoustimass® module: The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated dangerous voltage within the system enclosure that may be of sufficient magnitude to constitute a risk of electric shock. [. . . ] These wires match the positive (red) and negative (black) terminals on the back of each speaker. To extend the length of speaker cable, you will need a Bose 30-foot extension cable. To order this part, please call Bose customer service (request PN 186445-1 black; PN 186445-2 white). Or, splice in 18-gauge (. 75 mm2) or thicker cord (connecting + to + and ­ to ­). To purchase cables, see your dealer, electronics store, or call Bose customer service. Match the correct cable to the corresponding speaker location. · Speaker cables have blue connectors at one end, with L and R molded into the connectors. · The red collars on the + wire are labeled LEFT and RIGHT. Connect the wire end of one speaker cable to the terminals on the rear of the matching cube speaker array. Press the terminal tab on the back of the cube array to insert the marked wire into the red terminal and the plain wire into the black terminal. Repeat this step for each of the cube speaker arrays. Connect each cable to the corresponding left or right blue jack on the Acoustimass module. Figure 6 Speaker cable connections to the cube speaker array CAUTION: Make sure no strands of wire from any terminal touch any other terminal. Using the supplied 30-foot audio input cable, insert the DIN connector into the Acoustimass module, and the RCA plug into the supplied 3-foot adapter cable. Then, attach the DIN end of the 3-foot adapter cable to one of the unused ROOM output jacks (B, C, D) on the rear of the multi-room interface (Figure 10). To extend the length of the cables, use the supplied 50-foot extension cable. This cable connects between the 30-foot audio input cable and the 3-foot adapter cable (Figure 10). Connecting power to your system CAUTION: If you purchased a dual-voltage system, it is important that you set the speakers to the correct voltage. To do this, refer to "Selecting the correct voltage" on page 6. Follow these steps to connect power to your Acoustimass powered speaker system: 1. Plug the power cord from the Acoustimass module into an AC power (mains) outlet. Insert the power cords of the Lifestyle® system into an AC power (mains) outlet. Turn Acoustimass module power switch to the ON position. Operating in more than one room Your Lifestyle® PersonalTM music center can control up to four sets of Bose® powered speakers, allowing your family to enjoy four different audio sources (CD, radio, TV, etc. ) in up to four rooms. These rooms are referred to as room A, B, C, and D, with room A being the primary room (the one used for a one-room system). If two or more rooms are connected to your system, the Personal music center displays ROOM and HOUSE buttons, and room indicators (A, B, C, and/or D). [. . . ] Moving the module away from the corner will decrease bass. 14 Product Information Troubleshooting Problem What to do English System does not function at all · Make sure the power connector is plugged securely into the music center, the power cord is plugged securely into the Acoustimass® module, the power pack and power cord are plugged into operating AC wall outlets, and the module power switch is on. · Be sure to select a source (CD, AM/FM, etc. ). · Unplug the music center power pack for a minute, then reconnect it. This allows the unit to reset itself after a power surge or power interruption. [. . . ]