User manual BOSE LIFESTYLE 30 SERIES I

[. . . ] The exclamation point within an equilateral triangle, as marked on the system, is intended to alert the user to the presence of important operating and maintenance instructions in this owner's guide. CAUTION: To prevent electric shock, match wide blade of plug to wide slot, insert fully. Class 1 laser product This compact disc player is classified as a CLASS 1 LASER PRODUCT. The CLASS 1 LASER PRODUCT label is located on the bottom of the unit. CLASS 1 KLASSE 1 LUOKAN 1 KLASS 1 LASER LASER LASER LASER PRODUCT PRODUKT LAITE APPARAT CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. The compact disc player should not be adjusted or repaired by anyone except properly qualified service personnel. Class B emissions limits This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. Batteries Please dispose of used batteries properly, following any local regulations. Do not incinerate. Additional safety information See the additional instructions on the Important Safety Information page enclosed with this owner's guide. Please read this owner's guide Please take the time to follow this owner's guide carefully. [. . . ] PATENT D339, 606 L SYSTEM CONTROL R 2 R B A SPEAKERS OUTPUT REC TAPE PLAY AUX INPUT VIDEO SOUND MANUFACTURED: BOSE CORPORATION, FRAMINGHAM, MA 01701-9168 MADE IN U. S. A ANTENNA SEE INSTRUCTION MANUAL L R V L R Cable TV VCR To the module TV AM196573_05_V. pdf October 29, 2001 13 Setting Up (2) To direct video sound sources through your TV This is an alternative connection method. (See Figure 11. ) If your stereo TV has fixed audio outputs (the audio signal level doesn't change) and it allows you to select the source of the signal (VCR, laserdisc, cable, etc. ), then you can: · Connect your DVD player L and R outputs to the music center AUX inputs. · Connect the DVD video output to one of the video inputs on the TV. · Connect the coaxial digital audio output from your DVD player to the female RCA connection on the audio input cable (connecting the music center with the module), using a male-to-male RCA cable. · Connect your home theater components to the TV inputs. · Connect the TV fixed audio outputs to the VIDEO SOUND INPUTs on the music center. · Turn the TV speakers off or the volume all the way down. (If there is an internal/external speakers switch, select external speakers. Do not connect any speakers to the TV. ) · Turn off any special TV settings such as expanded stereo, mega-bass, phantom, or SAP. They prevent proper surround processing through your Lifestyle® system. · Set the TV balance control to the center of the dial or range. Stand the loop antenna on the base, following the instructions enclosed with the antenna. Move the loop part of the antenna as far as possible but at least 20 inches (50 cm) from the music center and at least 4 feet (1. 2 m) from the Acoustimass® module. Experiment with the orientation of the loop for optimum AM reception. Note: Outdoor antennas may be used with the music center antenna connections. To install an outdoor antenna, consult a qualified installer. Follow all safety instructions. Connecting to a cable radio signal To connect your system to the FM signal available from some cable TV companies, contact your cable provider for assistance. The connection is made to the FM 75 EXTERNAL antenna connector on the back of the system. CAUTION: Be certain that the installation includes a signal splitter so that only the FM band, not the cable TV band, is transmitted to the system. It is necessary to use a splitter that filters the signal to prevent any re-emissions of the TV spectrum through the system. Attaching the wire cover After all the connections are completed, attach the wire cover to the music center to hide the wires and jacks from view. The five tabs on the wire cover snap into matching slots on the music center back panel. Figure 15 The wire cover 16 October 29, 2001 AM196573_05_V. pdf Setting Up Installing the batteries in the remote control 1. Slide open the battery compartment on the back of the remote (Figure 16). Insert 3 AA or IEC-R6 1. 5V batteries, or the equivalent, as shown. Match the + and ­ symbols on the batteries with the + and ­ markings inside the compartment. [. . . ] · Weak FM stations will produce static in the surround speakers. Press the STEREO (2-speaker) button to minimize noise. STEREO · Make sure speaker cables are not damaged and the connections are secure. · Reduce the output level from any external components connected to the music center. · Check to be sure the audio input cable is connected to the music center FIXED OUTPUTs, not to SPEAKERS A or B. [. . . ]