User manual BOSE LIFESTYLE SA-1

[. . . ] The Bose® Lifestyle® Amplifier Owner's Guide January 4, 2002 AM262840_00_V. pdf Safety Information WARNING: To reduce the risk of fire or electric shock, do not expose the system to rain or moisture. CAUTION RISK OF ELECTRICAL SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED PERSONNEL. AV I S VS RISQUE DE CHOC ÉLECTRIQUE NE PAS OUVRIR ATTENTION : POUR RÉDUIRE LE RISQUE DE DÉCHARGE ÉLECTRIQUE, NE PAS RETIRER LE COUVERCLE (OU L'ARRIÈRE). IL NE SE TROUVE À L'INTÉRIEUR AUCUNE PIÈCE POUVANT ÊTRE RÉPARÉE PAR L'USAGER. S'ADRESSER À UN RÉPARATEUR COMPÉTENT These CAUTION marks are located on the bottom panel of your Lifestyle® stereo amplifier: The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated dangerous voltage within the system enclosure that may be of sufficient magnitude to constitute a risk of electric shock. [. . . ] These rooms are referred to as room A, B, C, and D, with room A being the primary room (the one used for a one-room system). If two or more rooms are connected to your system, the Personal music center displays ROOM and HOUSE buttons, and room indicators (A, B, C, and/or D). Figure 7 shows an example display for a two-room system. Figure 7 Sample display for a tworoom system Press the ROOM button to control a single room or two or more rooms that share a source Press the HOUSE button to control all connected rooms as one The room indicators tell you what was selected by the ROOM or HOUSE button 8 January 4, 2002 AM262840_00_V. pdf Setting Up Your Lifestyle® Stereo Amplifier Connecting the Lifestyle® stereo amplifier to a Lifestyle® media center CAUTION: Before making connections, turn the Lifestyle® system off and disconnect the media center from the AC (mains) power outlet. DO NOT plug the amplifier into an outlet until you have completed all other connections. Insert the single-connector end of the audio input cable into the SPEAKER ZONES 2 output jack on the rear panel of the media center (Figure 8). At the other end of the audio input cable, insert the 3. 5 mm mini-plug into the SYSTEM CONTROL jack on the rear panel of the amplifier. Insert the white RCA piggyback connector of the audio input cable into the L (left) INPUT jack. Insert the red RCA piggyback connector into the R (right) INPUT jack of the amplifier. Figure 8 Cable connections between the Lifestyle® media center and the Lifestyle® stereo amplifier Lifestyle® SA-1 stereo amplifier rear panel Lifestyle® media center rear panel 30-ft audio input cable (supplied) AM262840_00_V. pdf January 4, 2002 9 Setting Up Your Lifestyle® Stereo Amplifier Setting up the remote control You need to set up a second remote control to operate the ZONE 2 output. Remove the remote control battery cover and locate the miniature switches (Figure 9). Make sure that the house code settings (switches 1, 2, 3, and 4) match those in your first remote. Make sure switches 5, 7, and 8 are up, and switches 6 and 9 are down. Note: Refer to your Lifestyle® system owner's guide for more information on operating your system in more than one room. Figure 9 Setting up a Zone 2 remote control ON Setting Zone 2 Protocol For the SA-1 amplifier to work properly with a Lifestyle® media center, you will need to set the Zone 2 Protocol to Legacy mode (Figure 9a). While your Lifestyle® DVD system is on, press the Settings button on your remote control. Scroll down with the down-arrow button and select System Setup using the enter button. You will now see a menu entitled System Setup (1 of 3). Continue to scroll down through (2 or 3) to (3 of 3). The last item on System Setup (3 of 3) is Zone 2 Protocol. Use the right-arrow button to change the protocol from Normal to Legacy. Before using Zone 2, shut off the system and turn it on again; this ensures that the Zone 2 Protocol is reset to Legacy mode. On Off Mute All SOURCE / INPUT Figure 9a Setting Zone 2 Protocol Mute Settings ( ) System Setup (3 of 3) CD/DVD Changer TV FM/AM VCR AUX MENU / NAVIGATION Settings Tune Disc Settings Seek Enter Channel Chapter Preset Track Volume 1 4 7 2 5 8 0 PLAYBACK 3 6 9 Stop Pause Play Shuffle Repeat System Setup Enter Zone 2 Protocol: Legacy 10 January 4, 2002 AM262840_00_V. pdf Setting Up Your Lifestyle® Stereo Amplifier Connecting the Lifestyle® stereo amplifier to a Model 20 music center CAUTION: Before making connections, turn the Lifestyle® system off and disconnect the music center from the AC (mains) power outlet. [. . . ] Connect it to the other outputs on the amplifier. If the speaker plays, the problem is in the original cable that was connected to that speaker. If the speaker does not play, the problem is in that channel of the amplifier. · Check the speaker cable connections to be sure the cable connected to the SPEAKER OUTPUTS L at the amplifier are connected at the other end to the speaker on the left in your listening area. [. . . ]