User manual BOSE SL2 WIRELESS SURROUND LINK

[. . . ] Please take the time to follow the instructions in this owner's guide carefully. It will help you set up and operate your system properly and enjoy its advanced features. Please save this owner's guide for future reference. WARNING: To reduce the risk of fire or electrical shock, do not expose the product to rain or moisture. [. . . ] It is seldom necessary to point the SL2 transmitter at its receiver. This allows you to hide both from view if you like. the SL2 transmitter , identified on the label , is also distinguished by a single input jack (see Figure 3 on page 6). The SL2 receiver, which is also labeled, has two output jacks. Place the SL2 transmitter within 6 1/2 feet (2 meters) of the Acoustimass® module. Make sure it is within reach of an AC (mains) outlet. Place the SL2 receiver at the same end of the room as your surround speakers. It, too, should be within reach of an AC (mains) outlet. From 6 1/2 feet (2 meters) to 30 feet (9. Where the sides are unobstructed to allow for ventilation. Upright (neither upside down nor on a side) on the floor or other flat, stable surface. Note: If you experience any problem with communications between the SL2 transmitter and receiver, positioning them within line of sight to each other may be helpful. For further suggestions on how to deal with such problems, refer to "Troubleshooting" on page 9. Use the small power pack with the SL2 transmitter (Figure 3). The large power pack is for use with the SL2 receiver. Transmitter power pack AC power jack Receiver power pack Before you plug either of the supplied power packs into the wall, make all the other connections. Use the supplied transmitter cable to connect the SL2 transmitter to your Acoustimass® module, as follows (Figure 4): 1. Insert the single connector at one end of the cable into the input jack labeled Acoustimass Module on the back of the SL2 transmitter. Insert the green connector marked LR into the jack labeled Left Rear or Surround L. Connect the cable end of the transmitter power pack to the small jack labeled DC Power on the back of the SL2 transmitter. Plug the transmitter power pack into a nearby AC mains outlet. When the power supply is plugged in, a Status LED on the back of the transmitter blinks green until it links to the receiver. [. . . ] ⷠIf it continues to blink red, check the cable connection between the SL2 receiver and the surround speakers. Make sure the connections are secure and the cable wires are not touching each other, which can cause a short circuit. refer to "Connecting the SL2 receiver" on page 7. Reconnect the unit to the AC power outlet. [. . . ]