User manual BOSE WAVE MUSIC SYSTEM MULTI-CD CHANGER

[. . . ] Your Wave® music system requires updating before it can operate this accessory. Please take the time to follow the instructions in this owner's guide carefully. It will help you set up and operate your system properly and enjoy all of its advanced features. Save your owner's guide for future reference. [. . . ] After applying power, "PLEASE WAIT" appears on the display for about 30 seconds while the system prepares itself for operation. DO NOT insert any discs until this message disappears. For best FM reception, straighten the AC power cord as much as possible. Your Wave ® music system uses the power cord as an FM antenna. Bose® link connector Wave® music system AC POWER input Wave® music system Wave® music system AC power cord For best FM reception, straighten the power cord as much as !English An additional remote control is included with your Wave® music system Multi-CD Changer. This remote is identical to the one used to control your Wave® music system. So, you can use either remote to control the completed multi-CD system. just aim the remote at the front panel and press the buttons. The remote normally works within 20 feet of the front panel. The following diagram describes the buttons used for playing CDs using the disc changer. Press: Navigates between folders when playing MP3 CDs. Press to hear audio from an external source connected to either the AUX 1 or AUX 2 input on the changer (page 12). Note: Press-and-hold operations require holding the button down for at least one second. Note: Pressing FM/AM, CD, or AUX automatically turns on the Wave® music system to the source selected. note: While the Multi-CD changer is connected , you cannot change the Alarm Time if AM radio is selected. To change Alarm Time, please select a source other than AM or turn the system off. Throughout this owner's guide you will see button icons to the left of the operating instructions. Turning your multi-CD system on and off Press On/Off once to turn your multi-CD Wave® music system on or off. Press On/Off again to turn the system off. English You can load and unload discs with the system on or off. If the system is off or in the CD source mode, the first disc loaded starts playing automatically. [. . . ] You will not hear the connected device if just the left (L) or right (R) channel is connected. Press AUX again to switch between the AUX 1 and AUX 2 inputs. aUX 1 or AUX 2 appears on the display to confirm your selection. Adjust the volume using the Wave® music system remote control. [. . . ]