User manual BOSS 614CA

[. . . ] BUTTONS LOCATION AND FUNCTIONS MP3 MENU BUTTON 1 8 11 AUTOMATICALLY STORE / PRESET SCAN BUTTON 3 CD EJECT BUTTON PANEL MONO/ RELEASE STEREO BUTTON BUTTON VOLUME KNOB AUDIO BUTTON MUTE BUTTON PRESET MEMORY BUTTONS (M1~M6) SCAN BUTTON 10 4 2 7 9 12 POWER BUTTON 6 LOCAL/ DISTANT BUTTON 15 REMOTE CONTROL RECEIVER 17 PRESET EQUALIZER BUTTON BAND/ LOUDNESS BUTTON DISPLAY BUTTON SOURCE TUNING UP / DOWN TRACK UP / DOWN BUTTON / BUTTONS SUB-WOOFER FOLDER DOWN /UP BUTTONS AUX IN JACK 13 MP3 ENTER BUTTON 5 ID3 TAG INFORMATION BUTTON 16 14 18 19 1 2. HANDLING COMPACT DISCS MOISTURE CONDENSATION On a rainy day or in a very damp area, moisture may condense on the lenses inside the unit. Should this occur, the unit will not operate properly. In such a case, remove the disc and wait for about an hour until the moisture has evaporated. NOTES ON CDs 1. [. . . ] 19) FRONT (AND REAR PANEL) AUXILIARY INPUT JACKS This unit features AUX IN line input jacks on both the front (headphone type) and rear (RCA type) panels. PLEASE NOTE: AUX IN JACK IN PANEL These two inputs cannot be used simultaneously. If you have a source unit plugged into the rear panel jack and wish to listen to a portable device (such as an MP3 player) by using the front panel jack, be sure to power off the unit plugged into the rear unit to Left Audio avoid interference. Right Audio Ground Similarly, if you have a device plugged into the front panel jack and wish to listen to the unit plugged into 3. 5mm Audio In Cable (not included) the rear panel, be sure to turn off the front panel device. To select either the front or rear AUX IN device as a listening source, press the SOURCE button to select AUX mode. To cancel AUX IN listening, press SOURCE again. 1 2 3 RESET BUTTON The RESET button is located on the main unit (as shown on the diagram). To press it vertically with a ballpoint pen or metal object will activate it. The reset button is to be activated for the following reasons: Initial installation of the unit when all wiring is completed. All the function buttons do not operate. Note: If the unit cannot function normally after reseting, please use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the control panel. 7 7. AUDIO OPERATIONS 10) VOLUME KNOB Turn this knob to adjust desired volume level. 4) AUDIO BUTTON Press this button to select desired audio function. ORDER OF FUNCTION: VOLUME(VOL) -> BASS(BAS) -> TREBLE(TRE) ->BALANCE(BAL) ->FADER(FAD) While the selected function is displayed, turn Volume Knob to adjust the level within 5 seconds, otherwise the unit will return to volume adjustment mode. 2) MUTE BUTTON (MUTE) Press this button to mute the sound. 17) PRESET EQUALIZER BUTTON (EQ) Press this button to toggle the following EQ settings: FLAT->CLASSICS->POP M->ROCK M->DSP OFF At DSP OFF mode, EQ will be controlled by Bass/Treble setting. 13) BAND/LOUDNESS BUTTON (BAND/LOUD) Press the Band/Loudness Button for couple of seconds to switch the loudness on or off. When Loudness is on, display will show 'Loud On' for a few seconds. 8 8. RADIO OPERATIONS 11) AUTO MEMORY STORE/PRESET SCAN BUTTON (AS/PS) 1. PRESET SCAN: Press AS/PS button briefly to enter Preset Scan mode, it will scan all the preset stations in the memories, you can hear that it will stay on each station for about 5 seconds. AUTO MEMORY STORE: Press AS/PS button for couple of seconds to enter Auto Store mode, this feature will automatically scan the current band and enter up to 6 strongest stations into the 6 preset memories. To stop Auto Store & Scan, press the AS/PS button again. Press these buttons briefly to recall the stored stations in the selected band. Presetting stations manually, Press the BAND button to select the band for the stations to be preset. [. . . ] At this point press directory down (M5) again , it will move to the next level of directory. ID3 TAG Press DISPLAY button repeatedly to Display ID3 TAG information. If the MP3 file is available with ID3 TAG, pressing the display button repeatedly will show information in the following sequence: SONG TITLE > ARTIST> ALBUM TITLE If any of the ID3-TAG information is not available, pressing the DISPLAY button repeatedly will show information in the following sequence: UNKNOWN SONGNAME> UNKNOWN ARTIST> NO ALBUM TITLE If the MP3 file is without ID3 TAG, pressing the DISPLAY button, & "NO ID3 TAG" will be displayed. The file name & track number of the MP3 file will scroll repeatedly through the display during the playing of the MP3 file. 12 11. REMOTE CONTROL 1 2 3 4 5 6 7 8 9 10 11 12 13 14 OPERATIONS: Key 1. ID3/DISP Radio Mode Power On/Off CD Player Mode Power On/Off MP3 Mode Power On/Off Adjust Vol, Bas, Tre, Fad, Bal Display Clock Adjust Vol, Bas, Tre, Fad, Bal Display Clock Adjust Vol, Bas, Tre, Fad, Bal ID3 tag information Display Clock, Numeric key 0* 4. Stereo/Mono Stereo/FM Mono Tuning/Seek Up/Down Local/Distant Station Scan Mute Select Vol, Bas, Tre, Fad, Bal No Function Track Up/Down No Function No Function Mute Select Vol, Bas, Tre, Fad, Bal No Function Track Up/Down/ Numeric key 8*9* No Function No Function Mute Select Vol, Bas, Tre, Fad, Bal, 5. [. . . ]