User manual BOSS BV4200B

[. . . ] FEATURES Compatible with PAL DVD (Video CD) and NTSC DVD (Video CD) This player can play discs recorded in either PAL or NTSC format. · A single LSI chip now integrates all major DVD playback circuit functions including MPEG2 decoder, video D/A converter, and audio decoders. · L/R stereo analog audio outputs for connection to existing head unit aux inputs. · Supplied remote handles multi-function software (multi-language audio-track/subtitle, multi-angle, multistory, etc. ), plus all basic functions. [. . . ] Then you can change the minutes according to the operation described above. MUTE Press MUTE button on the front panel or MUTE button on the remote control to mute down the sound instantly. Volume Level Adjustment Pressing VOL+/- buttons on the front panel or VOLUME +/- on the remote control to increase or decrease the volume level. EQUALIZATION Press EQ button shortly to turn on equalization function and to select desired audio mode. There are four kinds of mode as below: FLAT CLAS POP ROCK EJECTING A DISC Press (EJECT) button on the DVD unit or on the remote control to eject the disc. FACEPLATE RELEASE ) button on the front panel Press REL ( to detach the removable faceplate. SOUND ADJUSTMENT Press SEL button on the front panel of the unit or on the remote control to select the desired adjustment mode. The adjustment mode will change in the following order: VOL (Volume) BAS (Bass) TRE (Treble) BAL (Balance) FAD (Fader) By pressing the VOL+/- buttons on the 15 SUBWOOFER Press EQ (SW) button on the front panel for several seconds to toggle subwoofer output. Press it for several seconds again to release this mode. MODE SELECTION Press MODE button on the front panel of the unit or MODE button on the remote control to select among radio, disc GENERAL OPERATION (DVD/VCD/CD/MP3) play mode and AV IN mode. LIQUID CRYSTAL DISPLAY Exhibit current frequency and activated functions on the display of the front panel. RESET FUNCTION RESET button is placed on the front panel and must be activated with either a ballpoint pen or thin metal object. The reset button is to be activated for the following reasons: - Initial installation of the unit when all wiring is completed. - All the function buttons do not operate. Note: if press RESET button, the unit can't work yet, please use a cotton swab soaked in isopropyl alcohol to clean the socket on the front panel. LAST PLAY MEMORY · During disc playback, if you press button on the front panel or (POWER) button on the remote control to turn off the unit and then press the button again to turn on the unit, the DVD unit will resume playing from the point that just interrupted. · During disc playback, if you press MODE button to switch to radio mode, TV mode or AV mode, then return to DVD mode again, the unit will resume playing from the point that just interrupted. · During disc playback, press REL button to release the front panel, the unit will enter into standby state. Then install the front panel again, the unit will resume playing from the point that just interrupted. If in AV mode or radio mode, release the panel then install again, the unit will remain in the previous mode. · Switch the ignition key to "ACC OFF" then switch to "ACC ON", the unit will remain in the previous mode. If in disc play mode, it will resume playing from the point that just interrupted. [. . . ] NO POWER · Check if the on/off button on the front of the player is set to on. · Check if AC or DC power plug of the mains unit is properly connected. · Check if there is power at the AC or DC outlet. · Check if the battery is properly connected to the DVD unit or if the voltage of the battery is too low. [. . . ]