User manual BOSS BV8250

[. . . ] BV8250 Contents In-Dash AM/FM DVD/MP3/CD Receiver With 5. 3 Widescreen Touchscreen TFT Monitor With Front Panel USB Port Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety Information. . . . . . . . . . . . . . . . . . . . . . . . . 3 Disc Notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] FM1 ST DX 106. 30 MHz TA LUD SWF POP DISC 11:08 Setting Audio Modes Touch the screen the DSP range (or press the EQ/LOUD button on the remote ) to select one of the preset sound modes . The information will display in the monitor as follow : DSP (Please note : press the button longer again to renew it . ) Reset Factory Settings RESET button is placed on the housing and must be activated with either a ballpoint pen or thin metal object. POP FLAT ROCK JAZZ CLASSIC DVD 11-0:44:36 LUD SWF POP DISC 11:08 SWF LUD RDM DSP INT CLK RPT TA OSD AF RESET The RESET button is to be activated for the following reasons: A. Initial installation of the unit when all wiring is completed. All the function buttons do not operate. Error symbol on the display. touch to select It`s depend on your habit to select the Audio mode . Scroll Caption Adjustment In Radio mode: You can adjust your desired scroll caption , the method of the operation as follow: A). Press and hold the SETUP button (for about 2 seconds) on the remote control, the adjustment scroll bar will display on the screen . Use the VOL+/- to select among of the "A, B, C . . . . X, Y, Z, and blank ", and use the / button on the front panel 18 Radio Operation Listening to the Radio Switching To Radio Mode MOD FM1 FM2 FM3 AM1(MW1) Touch the MOD range repeatedly on the screen to select the RADIO mode. the following information will appears as below: FM1 ST AM2(MW2) ( You can also press the BND on front panel repeatedly to select the band . ) 106. 30 MHz DX TA CH 6 LUD 1 4 SWF 2 5 POP 3 6 DISC 11:08 MOD Start Searching For a Station Manual Search During Radio mode, briefly touch the screen of " " section or press the " " on front panel to increase frequency by one step of channel spacing . Briefly touch the " " section or press the " " button on the front panel to decrease frequency by one step of channel spacing . BND FM1 ST 106. 30 MHz DX TA CH 6 LUD VOLUME- SWF SEL POP DISC 11:08 VOLUME+ ST/MON LOC APS Automatic Search During Radio mode, touch and hold (for more than 2's ) the screen of " / " section or press longer the " / " on the front panel to start search for a radio station automatically . FM1 ST 106. 30 MHz DX TA CH 6 LUD SWF SWF LUD TA POP DISC DSP 11:08 CLK AF PTY When an FM stereo broadcast is hard to receive Touch " Touch " " to next . " to previous . ST/MON Touch the ST/MON section on touch screen (or press ST/MO button on the remote) to select the MONO or STEREO mode . Selecting The Frequency Band BND ( When Stereo mode is activated, the ST symbol will appear . ) Touch the BND section on the touch screen repeatedly to select the band , screen band will show in turn : 19 Radio Operation To tune in strong-singnal FM Station only (LO/DX function) Touch the LOC section on the touch screen (or press LO/DX button on the remote) to select the LOCAL or DX mode . ( You can choose between the LOCAL and DX(DISTANCE) mode for local or long-distance traffic news . ) LOC Automatic Memory Storing & Program Scanning Automatic Preset Setup In Radio Mode, Touch and keep the APS section on the touch screen (or swing and hold the SEL knob in direction of the APS/DISP) for about 2 seconds to active automatic station storage. The radio searches within the current frequency band, e. g. FM1, for the stronger signal level until the search cycle has finished . The six strongest stations are then allocated to the corresponding storage locations . Then the station of the first storage location is set . APS Storing Stations In Memory Setting Memory Press the /CH 1-6 button repeatedly on the front panel to preset stations at radio mode . ( Or touch the screen the 1-6 sections ) FM1 ST Scan Function APS 106. 30 MHz DX TA CH 6 LUD 1 4 SWF 2 5 POP 3 6 DISC 11:08 MOD In Radio mode, briefly touch the APS section on the touch screen the radio briefly plays all the preset stations of the frequency band . BND RDS FUNCTION Touch to preset station With this system, a total of 30 stations can be stored in the memory of six buttons. Each band stores up to six preset stations. The stations might be FM1, FM2, FM3, AM1(MW1), and AM2(MW2) band. [. . . ] To skip to the next or last track, touch or press the or . Press the or buttons for Fast Forward or Fast Reverse playback. REPEAT play modes are also available by repeatedly pushing REPEAT until the desired mode is found. 33 Other Main Operation MP3/WMA/JPEG/MPEG4 DISC PLAY When you insert a disc which contains MP3, WMA or JPEG files, the different file types are detected, and a list of the files are produced, as shown in the diagram below. 4 3 2 00:56 003/112 04:07 5 6 Repeat one 1 . [. . . ]