User manual BOSS BV9060B

[. . . ] A dirty or defective disc may cause sound dropouts while playing. To enjoy optimum sound, handle the disc as follows. To keep the disc clean, do not touch the surface (P . 1). NOTES ON DISCS If you use the discs explained below, the sticky residue can cause the CD to stop spinning and may cause malfunction or ruin your discs. Do not use second-hand or rental CDs that have a sticky residue on the surface (for example, from peeled-off stickers or from ink, or glue leaking from under the stickers). There are paste residue. [. . . ] The D. C. P can easily be damaged by shocks. After removing it, place it in a protective case and be careful not to drop it or subject it to strong shocks. When the release button is pressed and the D. C. P is unlocked, the car's vibrations may cause it to fall. To prevent damage to the D. C. P always store it in a protective case after detaching it. , The rear connector that connects the main unit and the D. C. P is an extremely important part. Be careful not to damage it by pressing on it with fingernails, pens, screwdrivers, etc. Socket Note: If the D. C. P is dirty, wipe off the dirt with soft, dry cloth only. And use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the D. C. P . E-5 5. WIRING DIAGRAM (20 PIN HARNESS PLUG) ANTENNAJACK ANTENNAPEXT ENDERP CABLE FUSE 20-PIN AUDIO/POWER HARNESS (See Figure 1) AUX IN WHITE L-CH YELLOW SUB WOOFER BLUE RCA-TO-RCA CABLES (not supplied) SUB-WOOFER R-CH WHITE RED REAR LINE OUT GREY WHITE RED R-CH RCA-TO-RCA CABLES (not supplied) L-CH FRONT LINE OUT BLACK WHITE RED R-CH L-CH AMP BLUE Power Antenna Connect to power antenna or amplifier, If not used, Tape bare end of wire. BLACK Ground Connect to ground terminal or Clean unpainted metal part of chassis Memory/Battery YELLOW Connect to battery or 12 volt power source that is always live. The radio will not work if this wire is not connected RED Accessory/Ignition Connect to existing radio wire or radio fuse. 20-PIN AUDIO/POWER HARNESS LEFT FRONT WHITE-BLACK LFWHITE LF+ RIGHT FRONT GREY-BLACK RF1 GREY RF+ 2 3 4 5 6 7 8 9 10 LEFT REAR GREEN-BLACK LR GREEN LR+ RIGHT REAR VIOLET-BLACK RRVIOLET RR+ 11 12 13 14 15 16 17 18 19 20 Figure 1 Pin View PIN 1 2 3 4 5 6 7 8 9 10 WIRE COLOR GREY/BLACK GREY VIOLET VIOLET/BLACK GREEN GREEN/BLACK RED BLACK RED FUNCTION/LABEL RIGHT FRONT SPEAKER (-) RIGHT FRONT SPEAKER (+) RIGHT REAR SPEAKER (+) RIGHT REAR SPEAKER (-) LEFT REAR SPEAKER (+) LEFT REAR SPEAKER (-) IGNITION(ACC) REAR PRE-AMP LINE OUT COMMON RIGHT REAR PRE-AMP LINE OUT PIN 11 12 13 14 15 16 17 18 19 20 WIRE COLOR WHITE WHITE/BLACK BLUE YELLOW BLACK WHITE RED BLACK WHITE FUNCTION/LABEL LEFT FRONT SPEAKER (+) LEFT FRONT SPEAKER (-) POWER ANTENNA BATTERY(+) CHASSIS GROUND LEFT FRONT PRE-AMP LINE OUT RIGHT FRONT PRE-AMP LINE OUT FRONT PRE-AMP LINE OUT COMMON LEFT REAR PRE-AMP LINE OUT E-6 6. BASIC OPERATIONS 1) PANEL RELEASE BUTTON (REL) Press this button to remove the control panel. 12) POWER ON/OFF BUTTON Press this button to turn on or off the power. 5) DISPLAY BUTTON (DISP) Press this button briefly, the LCD will display the clock for about 2 seconds, then return to previous display mode. The preset number will appear on the display accompanied by a beep, this indicates that the station has been stored into memory. 13) BAND/LOUDNESS BUTTON (BAND/LOUD) This a dual function button. Press this button shortly to change between BAND FM1, FM2, FM3 or AM/MW bands. Press this button for couple of seconds to turn Loudness function on or off. 14) TUNING / SEEK UP AND TUNING / SEEK DOWN BUTTONS 1. Press these buttons briefly, and the unit will operate in AUTO SEARCH tuning mode, the radio will tune up or down to the next station and remain on that station. 2. Press these buttons for more than 2 seconds, operate as MANUAL SEARCH buttons, under this mode the tuning frequency will advance up or down rapidly when the button is pressed. If the buttons are not pressed within 3 seconds, they will return to auto search mode. 8) MONO STEREO BUTTON (MO/ST) When you receive a station, "ST" on the display will be on. 9) SCAN BUTTON(SCAN) Press this button, the radio will tune up to search stations, the available stations will blink and stay on the display for a few seconds. 6) LOCAL/DISTANT BUTTON (LOC) During station tuning, this button allows you prior to access strong local station only (Local mode), or to access a wider range of using distant mode (DX). When powered on, DX mode will be defaulted automatically; Press LOC button briefly to select Local mode and "LOCAL symbol " on the LCD will light up for a few seconds. E-9 9. CD OPERATIONS M1) PAUSE BUTTON (PAUSE) Press this button to pause CD play, press again to release pause. [. . . ] (2) SEARCH DIRECTORY BY USING VOLUME KNOB Under MP3 play mode, press MP3 MENU BUTTON three times, Then the first Directory name is shown. RotateVOLUME KNOB counter-clockwise first to navigate through the directory list, press MP3 ENTER BUTTON to select the desired directory. To select the tracks under the selected directory, by Rotating VOLUME KNOB counter-clockwise first, then press MP3 ENTER BUTTON to confirm when desired track is found. (D) NAVIGATING THROUGH DIRECTORY BY USING M5/M6 BUTTON Press directory up (M6) or directory down (M5) buttons to skip the current directory forward or backward by one position. In a multi-level directories disc, the movement will take place at the current level until the last directory is reached. [. . . ]