User manual BOSS BV9455 PART 1

[. . . ] Before playing, clean the discs with an optional cleaning cloth. Wipe each disc from the centre out (P . 4). P8 . Be sure to use CDs with disc mark RECORDABLE REWRITABLE P4 . Do not use solvents such as benzine, thinner, commercially available cleaners, or antistatic spray intended for analog discs. Only for this unit. [. . . ] Pulling the levers makes it possible to remove the unit from the dashboard. Trim Plate Installation: Push the trim plate against the chassis until it is fitted. You must do this before you install the front panel, otherwise it can't be attached. DIN REAR-MOUNT (METHOD B) Installation using the screw holes on the sides of the unit. Fastening the unit to the factory radio mounting bracket. Select a position where the screw holes of the bracket and the screw holes of the main unit become aligned (are fitted) and tighten the screws at 2 places on each side. Hook (Remove this part) Note: the mounting box, outer trim ring, and half-sleeve are not used for method B installation. 2 4 3 2 5 5 E-4 4. DETACHABLE CONTROL PANEL (D. C. P . ) Removing The Detachable Control Panel (D. C. P . ). 1. Remove the D. C. P . PANEL RELEASE BUTTON Attaching the DCP 2 A B 1. Attach the panel at the right side first, with point B on the main unit touching point A on the D. C. P (As shown on the digram). Then press the left side of D. C. P onto the main . unit until a "click" sound is heard. CAUTION DO NOT insert the D. C. P from the left side. 2) MUTE BUTTON (MUTE) Press this button to mute the sound. 17) PRESET EQUALIZER BUTTON (EQ) Press this button to toggle the following EQ settings: FLAT->CLASSICS->POP M->ROCK M->DSP OFF At DSP OFF mode, EQ will be controlled by Bass/Treble setting. 13) BAND/LOUDNESS BUTTON (BAND/LOUD) Press the Band/Loudness Button for couple of seconds to switch the loudness on or off. When Loudness is on, display will show 'Loud On' for a few seconds. E-8 8. RADIO OPERATIONS 11) AUTO MEMORY STORE/PRESET SCAN BUTTON (AS/PS) 1. PRESET SCAN: Press AS/PS button briefly to enter Preset Scan mode, it will scan all the preset stations in the memories, you can hear that it will stay on each station for about 5 seconds. 2. AUTO MEMORY STORE: Press AS/PS button for couple of seconds to enter Auto Store mode, this feature will automatically scan the current band and enter up to 6 strongest stations into the 6 preset memories. To stop Auto Store & Scan, press the AS/PS button again. 7) STATION PRESET BUTTONS (M1-M6) 1. Press these buttons briefly to recall the stored stations in the selected band. 2. Presetting stations manually, Press the BAND button to select the band for the stations to be preset. Use Tuning Up/Down to tune in the stations to be preset. Press the Preset button at which you want to store the station for at least 2 second. [. . . ] EJECT BUTTON Press this button to eject the CD from the unit. The receiver will switch to radio mode automatically. EJECT BUTTON E - 10 10. REMOTE CONTROL 1 2 3 4 5 6 7 8 9 10 11 12 13 14 OPERATIONS: Key 1. Front panel is not properly fixed into its place Adjust the installation angle to less than 30 degrees. The fuse is blown. Disc cannot be loaded or ejected Presence of CD disc inside the player. [. . . ]