User manual BOSS CHAOS SE950

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual BOSS CHAOS SE950. We hope that this BOSS CHAOS SE950 user guide will be useful to you.

Lastmanuals help download the user guide BOSS CHAOS SE950.


Mode d'emploi BOSS CHAOS SE950
Download
Manual abstract: user guide BOSS CHAOS SE950

Detailed instructions for use are in the User's Guide.

[. . . ] In such a case, remove the disc and wait for about an hour until the moisture has evaporated. NOTES ON CDs 1. A dirty or defective disc may cause sound dropouts while playing. To enjoy optimum sound, handle the disc as follows. To keep the disc clean, do not touch the surface (P . 1). NOTES ON DISCS If you use the discs explained below, the sticky residue can cause the CD to stop spinning and may cause malfunction or ruin your discs. [. . . ] The D. C. P can easily be damaged by shocks. After removing it, place it in a protective case and be careful not to drop it or subject it to strong shocks. When the release button is pressed and the D. C. P is unlocked, the car's vibrations may cause it to fall. To prevent damage to the D. C. P always store it in a protective case after detaching it. , The rear connector that connects the main unit and the D. C. P is an extremely important part. Be careful not to damage it by pressing on it with fingernails, pens, screwdrivers, etc. Socket Note: If the D. C. P is dirty, wipe off the dirt with soft, dry cloth only. And use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the D. C. P . 7 6. WIRING DIAGRAM (20 PIN HARNESS PLUG) ANTENNA CABLE INPUT FUSE 20-PIN AUDIO/POWER HARNESS (See Figure 1) REAR LINE OUT GREY WHITE L-CH RCA-TO-RCA CABLES (not supplied) RED R-CH AMP BLUE Power antenna wire and remote turn on lead. BLACK Ground Connect to ground terminal or Clean unpainted metal part of chassis YELLOW Memory/Battery Connect to a constant 12 volt source. The radio will not work if this wire is not connected. RED Accessory/Ignition - Connect to a switched 12 volt source. 20-PIN AUDIO/POWER HARNESS LEFT FRONT WHITE-BLACK LFWHITE LF+ RIGHT FRONT GREY-BLACK RF1 GREY RF+ 2 3 4 5 6 7 8 9 10 LEFT REAR GREEN-BLACK LR GREEN LR+ RIGHT REAR VIOLET-BLACK RRVIOLET RR+ 11 12 13 14 15 16 17 18 19 20 Figure 1 Pin View PIN 1 2 3 4 5 6 7 8 9 10 WIRE COLOR GREY/BLACK GREY VIOLET VIOLET/BLACK GREEN GREEN/BLACK RED BLACK RED FUNCTION/LABEL RIGHT FRONT SPEAKER (-) RIGHT FRONT SPEAKER (+) RIGHT REAR SPEAKER (+) RIGHT REAR SPEAKER (-) LEFT REAR SPEAKER (+) LEFT REAR SPEAKER (-) IGNITION(ACC) REAR PRE-AMP LINE OUT COMMON RIGHT REAR PRE-AMP LINE OUT PIN 11 12 13 14 15 16 17 18 19 20 WIRE COLOR WHITE WHITE/BLACK BLUE YELLOW BLACK FUNCTION/LABEL LEFT FRONT SPEAKER (+) LEFT FRONT SPEAKER (-) POWER ANTENNA BATTERY(+) CHASSIS GROUND WHITE LEFT REAR PRE-AMP LINE OUT 8 7. BASIC OPERATIONS 1) PANEL RELEASE BUTTON (REL) Press this button to remove the control panel. 12) POWER ON/OFF BUTTON Press this button to turn on or off the power. Press the Preset button at which you want to store the station for at least 2 second. The preset number will appear on the display accompanied by a beep, this indicates that the station has been stored into memory. 13) BAND/LOUDNESS BUTTON (BAND/LOUD) This a dual function button. Press this button shortly to change between BAND FM1, FM2, FM3 or AM bands. Press this button for couple of seconds to turn Loudness function on or off. DUAL FREQUENCY SWITCH Unit is defaulted in U. S. A frequency, if EURO frequency is required, a sharp pen is needed to switch the button on the left side of the chassis to EURO frequency. US EU 14) TUNING / SEEK UP AND TUNING / SEEK DOWN BUTTONS 1. Press these buttons briefly, and the unit will operate in AUTO SEARCH tuning mode, the radio will tune up or down to the next station and remain on that station. Press these buttons for more than 2 seconds, operate as MANUAL SEARCH buttons, under this mode the tuning frequency will advance up or down rapidly when the button is pressed. If the buttons are not pressed within 3 seconds, they will return to auto search mode. 8) MONO STEREO BUTTON (MO/ST) When you receive a station, "ST" on the display will be on. 9) SCAN BUTTON(SCAN) Press this button, the radio will tune up to search stations, the available stations will blink and stay on the display for a few seconds. [. . . ] If the MP3 file is available with ID3 TAG, pressing the display button repeatedly will show information in the following sequence: SONG TITLE > ARTIST> ALBUM TITLE If any of the ID3-TAG information is not available, pressing the DISPLAY button repeatedly will show information in the following sequence: UNKNOWN SONGNAME> UNKNOWN ARTIST> NO ALBUM TITLE If the MP3 file is without ID3 TAG, pressing the DISPLAY button, & "NO ID3 TAG" will be displayed. The file name & track number of the MP3 file will scroll repeatedly through the display during the playing of the MP3 file. 14 12. REMOTE CONTROL 1 3 4 5 6 7 8 9 10 OPERATIONS: Key 1. Numeric Key(1) (2) (3) (4) 2 11 12 13 14 Radio Mode Power On/Off CD Player Mode Power On/Off MP3 Mode Power On/Off Select Vol, Bas, Tre, Fad, Bal Select Vol, Bas, Tre, Fad, Bal Select Vol, Bas, Tre, Fad, Bal Adjust Vol, Bas, Tre, Fad, Bal Tuning/Seek Up/Down Station Scan Band/Loudness Local/DX Mute FM Mono/Stereo Preset station 1 Preset station 2 Preset station 3 Preset station 4 Adjust Vol, Bas, Tre, Fad, Bal Track Up/Down No Function Loudness No Function Mute No Function Pause CD Scan Repeat Shuffle No Function No Function Change to Radio Mode No Function Preset EQ Display Clock, Track, Play Time Adjust Vol, Bas, Tre, Fad, Bal Track Up/Down or Numeric Key 8 (DN), 9(UP)* No Function Loudness or Enter* No Function Mute No Function Pause CD Scan Repeat Shuffle (5) Preset station 5 (6) Preset station 6 11. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE BOSS CHAOS SE950

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual BOSS CHAOS SE950 will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag