User manual BOSS DD-3

[. . . ] The manual should be saved and kept on hand as a convenient reference. Main Features A full 23-second long delay provides plenty of time for loop play and sound-on-sound. The Memory function allows you to store up to four tones in the DD-3 itself, independent of the panel settings. You also get "seamless switching, " with memories switched smoothly as the reverberation continues. Features a Delay mode with a total of eleven effects, including new "SMOOTH, " "TWIST" and some effects modeled on analog and tape echo effects. [. . . ] 31) OUTPUT Jacks (A (MONO), B) This jack is for connection to a guitar/bass amp, another effects processor, mixer, MTR, or the like. For MONO use, make the connection to the A (MONO) jack. 4) 20 How to Use Each Mode How to Use SOS (Sound On Sound) 1. Turn the MODE knob to "SOS. " 2. Press the ON/OFF pedal to start recording. Play what is to be used as the basic phrase. The remaining memory is indicated as a percentage in the display. fig. 29 Blink 3. Press the ON/OFF pedal again to stop recording. Loop playback of the recorded phrase begins at the same time you press the pedal. The loop time is indicated in the display as shown below. The TEMPO indicator also flashes. fig. 30 4. If you want to save it as a setting for the Memories (1­4), then carry out the Write procedure (p. 10). 23 How to Use Each Mode How to Use DUAL Although DUAL mode features a short delay and long delay connected in series, you can change the delay time for the short delay. Turn the MODE knob to "DUAL. " 2. Hold down the ON/OFF pedal until "SHORT" appears in the display. In this case, the short delay's delay time is indicated. fig. 36 3. You can change the delay time by continuing to hold down the ON/OFF pedal as you turn the DELAY TIME knob. * This is set at the factory to "SHORT 50msec, LONG 300 msec. " * This setting is preserved even after the power is turned off. If you want to save it as a setting for the Memories (1­4), then carry out the Write procedure (p. 10). 24 How to Use Each Mode How to Use MODULATE You can change the MODULATE modulation rate and depth settings. Turn the MODE knob to "MODULATE. " 2. Hold down the ON/OFF pedal until "r" appears in the display. [. . . ] 18, 21 Sound On Sound . . . . . . . . . . . . . . . . . . . . . . . . . 18, 21 STANDARD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 E Effect Sound . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . External Pedal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . F Factory Defaults . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]