User manual BOSS DIABLO DD3600

[. . . ] The manual should be saved and kept on hand as a convenient reference. Main Features The RE-20 uses COSM technology to faithfully simulate the characteristics of the famed Roland SPACE ECHO RE-201. Faithfully reproduces the characteristics of the RE-201, including the echo's distinctive wowand flutter-induced wavering and the compressed sound obtained with magnetic saturation. The Mode Selector carries on the tradition of the RE-201, offering twelve different reverberation effects through various combinations of the three playback heads and reverb. You can set delay times with the TAP input pedal and use an expression pedal (sold separately) for controlling parameters. [. . . ] When connection cables with resistors are used, the sound level may be extremely low, or impossible to hear. For information on cable specifications, contact the manufacturer of the cable. · The INPUT A/MONO jack doubles as a power switch. Inserting a plug in the INPUT A/MONO jack turns on the power; the power is switched off when the plug is disconnected. Be sure to unplug the cable from this jack when the RE-20 is not in use. · If there are batteries in the unit while an AC adaptor is being used, normal operation will continue should the line voltage be interrupted (power blackout or power cord disconnection). · Once the connections have been completed, turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices. When powering up: Turn on the power to your guitar amp last. When powering down: Turn off the power to your guitar amp first. · Always make sure to have the volume level turned down before switching on power. * Adjusting the MODE SELECTOR knob while the twist effect is being applied cancels the twist effect. * You can apply the twist effect with an external expression pedal. For more detailed information, refer to "Control Using an Expression Pedal" (p. 16). Switching the Repeat Rate and Delay Time Mode The RE-20 features two modes to select from. Normal mode: The REPEAT RATE knob functions over the same range as the RE-201. Additionally, the maximum value that can be set for the tap delay time is three seconds (when the MODE SELECTOR knob is set to the 3 or 7 position). Long mode: The range for the REPEAT RATE knob setting is expanded to twice the normal setting. Additionally, the maximum value that can be set for the tap delay time is six seconds (when the MODE SELECTOR knob is set to the 3 or 7 position). 1. Turn off the RE-20. * Disconnecting the plug from the INPUT A/MONO jack switches off the power. 2. While holding down the TAP pedal, turn on the power to the RE-20. The virtual tape display flashes, and then remains lit. * Connecting the plug to the INPUT A/MONO jack switches on the power. 3. [. . . ] Is the volume turned down on the connected guitar/keyboard, effects processor, or other device? Check the settings on the connected equipment (p. Only the effect sound is output when the DIRECT switch is set to OFF. To output the direct sound, set the switch to ON. [. . . ]