User manual BOSS DVD4000B

[. . . ] Use Authorized Service Centres Do not attempt to disassemble or adjust this precision product. Please refer to the Service Centre list included with this product for service assistance. For Installation The unit should be installed in a horizontal position with the front end up at a convenient angle, but not more than 30°. USE THIS PRODUCT SAFELY When Driving Keep the volume level low enough to be aware of road and traffic conditions. When Car Washing Do not expose the product to water or excessive moisture. [. . . ] The reception band will change in the following order: FM1 FM2 FM3 AM1 AM2 STATION STORING Press any one of the preset buttons (1 to 6) on the front panel to select a station, which had been stored in the memory. Press this button for several seconds, current station is stored into the number button. MONO/STEREO Press ST/TITL button on the front panel to select mono or stereo mode. You can sometimes improve reception of distant stations by selection mono operation. RDS (RADIO DATA SYSTEM) OPERATION - Setting RDS Mode Press AF/REG button on the front immediately to switch on or off RDS mode. Whenever RDS is switched on, symbol "AF" appears on the display. Program name is displayed on receiving a RDS station. "AF" starts blinking if the broadcasting signal getting worse. "ALARM" will be displayed when an emergency broadcasting is received; meanwhile sound output level will be adjusted to the preset output level automatically when the volume control is set at minimum. - Regional Program Operation Press AF/REG button for several seconds to switch on or off region mode. Some broadcasting stations change their program from normal broadcasting to regional broadcasting for a certain time period. The purpose of this key is to reduce unwanted EON TA switching, which EON TA information was received from current station and the radio switched to that EON linked station, but no information could not be received because the EON linked station is located too far from that area. So the radio is switched back to current station again. In above operation, a customer listen to a wrong program or mute sound for a while. EON TA LOCAL mode When the filed strength level of EON linked is less than threshold level, the radio does not switch that station, and a customer can hardly listen to any disturbances. When EON TA LOCAL mode is selected, "EON TA LO" on numeric display is indicated for a few seconds. EON TA DISTANCE mode EON TA switching is try to implemented by the information of current station. When EON TA DISTANCE mode is selected, "EON TA DX" on numeric display is indicated for a few seconds. The RDS data used are the PI, PS, AF, TP, TA, EON and PTY data. PI: Program Identification Code Code for identifying programs PS: Program Service Name Broadcast station name data expressed in alphanumerically characters AF: Alternative Frequencies Frequency list of broadcasting stations transmitting the same program OPERATION TP: Traffic Program Identification Identification data for traffic information broadcasting station TA: Traffic Announcement Identification Identification data showing traffic information is being transmitted or not EON: Enhanced Other Networks Information Broadcasting information on PI, AF, TP, TA, etc. relating to networks other than the network used for current reception PTY: Program Type Code Contents of programs such as news, light music, sports etc. DISC (DVD/VCD/CD/MP3) OPERATION STOPPING PLAY - Briefly press the (Stop) button to stop the unit playback, when the button is pressed, normal playback will continue. - Press (Stop) button twice to stop the playback and go back to initial Track/Chapter. [. . . ] NO PICTURE · Check if the monitor or TV is switched on. · Check if select proper mode, such as Disc Play mode and AV mode. DISTORTED PICTURE · Check the disc for fingerprints and clean with soft cloth, wiping from centre to edge. · Sometimes a small amount of picture distortion may appear. [. . . ]