User manual BOSS HR8-PAK

[. . . ] · Do not install this product in a location which allows the monitor screen to be visible to the driver of the vehicle. In some states and countries, the viewing of images on a screen inside a vehicle is illegal, even by people other than the driver. Be sure that the installation and operation of this system is in compliance with local rules and regulations. [. . . ] Do not place objects on or suspend objects from the power cord, as this may damage the cord. What is included? When first unpacking your new video monitor, please check first that the package contains all of the items below. If something is missing, contact the store where you purchased the player. · One pair of universal headrests with built-in 8-inch TFT video monitors · Remote control · On pair of adapter tubes (needed when replacing headrests with large diameter posts · Video/power interface cable with inline fuse HR8-PAK User's Manual - page 3 Monitor Controls and Features 1 2 3 4 5 1 LCD DISPLAY 2 IR REMOTE CONTROL SENSOR 4 MENU BUTTON Press this button to enter the OSD (On-Screen Display) menu system for controlling various parameters for the display. 3 UP/DOWN BUTTONS Use these buttons for changing settings within the OSD (On-Screen Display) menu system 5 POWER ON/OFF Installing the monitor Remove the existing headrest from the seat. Adjust the spacing of the posts of your new headrest monitor to match those of the holes in the seatback. To do so, grasp one post in each hand, and push one forward and one back while pull them apart (to increase the distance) or push them together (to reduce the distance). Compare the outside diameter of the new headrest posts with the holes in the seatback. If the holes in the seatback are significantly larger than the new headrest posts, you may need to use the adapter tubes (included). These tubes are approximately 12mm in diameter. If needed, slide an adapter tube onto each of the headrest posts. Insert the cable into the proper hole in the seatback and feed the cable down into the seatback and out the bottom (if you are unable to do this properly, see a professional mobile video installer). Insert the headrest posts into the seatback and pull the cables from below the seat to take up the slack. Run them to the location of the video source unit (such as a DVD player) and connect the wires as shown in the System Wiring diagram. HR8-PAK User's Manual - page 4 Remote Control Features 1 POWER Press to turn the monitor ON or OFF. 2 VIDEO SELECT 1 2 3 MENU VIDEO SELECT Use this button to switch between Video Source 1 and VIideo Source 2. 3 MENU BUTTON Press this button to enter the OSD (On-Screen Display) menu system for controlling various parameters for the display. 4 5 MODE SELECT 4 UP/DOWN BUTTONS These buttons are used to increase or decrease parameters in the on-screen display menu system. 5 MODE HR8-PAK This monitor features presets for Picture, Brightness, Color and Contrast. You may prefer these to setting up your own using the OSD system. Press MODE to access these presets. Changing the battery in the remote control The remote battery is held in a small "drawer" on one edge of the remote. [. . . ] If problems persist, read the following troubleshooting tips which may help eliminate the problems. CAUSE Power cord is not properly connected. Video input cables not properly connected. [. . . ]