User manual BOSS ONYX N2400.2

[. . . ] Immediately unplug the power cord and send the monitor to your local dealer or service center as soon as possible: a) if there is smoke or any peculiar odor present during use b) if there is damage to any of the internal components 4. To avoid damage to the monitor and risk of electronic shock, do not permit any of this equipment to become damp or wet from water or liquid. If this does occur, immediately unplug the power cord and send the monitor to your local dealer or service center as soon as possible. [. . . ] Do not attempt to repair, open or disassemble any of the components. Dangerous high voltages are present which may result in electric shock. Use only a power source with 12 volts DC (negative ground). Do not place objects on or suspend objects from the power cord, as this may damage the cord. Do not twist or place the power cord near any source of heat in the vehicle. Do not attempt to repair a damaged, broken or faulty power cord. Avoid dropping any metal objects or inflammable items into the monitor ventilation slots. After the monitor is installed, do not arbitrarily pull it down or strike it. Take the appropriate precautions to ensure that it is not damaged during the installation. 7 Measurements Push on the headrest with your fingers to make sure there are no obstructions that would hinder the installation. Use paper template to mark the area to be cut. Cut the Headrest Using an adjustable-depth blade, start your cut 1/4 inch inside one corner and cut diagonally across, stopping 1/4 inch in from the other corner. Repeat the procedure for the other two corners. Remove Foam & Obstructions Carefully peel back the material. Set the adjustable blade to one inch depth and cut around the edges of the hole, staying 1/4 inch inside the edge. Pull up one corner of the foam and use the blade to cut underneath. Remove small section at a time, using the pull up and cut method for uniform depth. Use a dremel or other appropriate tool to remove other obstructions. Insert the monitor to measure the fit and make adjustments if necessary 8 Route the Cable Through the Headrest Run the supplied cable through the opening and out to the bottom of the headrest. [. . . ] Insert the monitor to measure the fit and make adjustments if necessary 8 Route the Cable Through the Headrest Run the supplied cable through the opening and out to the bottom of the headrest. If possible, conceal the wires using a shaft covering. Connect the power, ground and video leads to test the MONITOR. [. . . ]