User manual BOSTON ACOUSTICS INSTALLATION

[. . . ] Behind the mounting surface there must be 11/2-inches (38mm) clearance on either side of the short sides. For new construction installations, we offer new construction brackets. The NCB brackets act as a perfect guide when cutting the wallboard. [. . . ] Insert a long, bent piece of wire and rotate to confirm that there are no obstructions behind the chosen location. Run the wire from the amplifier location to the cutout. Allow for an extra foot of wire at the cutout. The HSi speaker jack will accept either bare wire up to 14-gauge, or single banana plugs. The speaker must slide into the wall woofer side first. If you wish to paint your speakers or grilles it should be done prior to installation of the grille. The speakers may be painted before or after they are installed. Insert the supplied paint mask into the frame of the speaker. If you are using spray paint, apply two light coats. If you are applying paint with a brush or roller, thin the paint and apply two very light coats. This helps prevent excessive paint buildup or "runs" on the frame. After the paint has dried, use the finger pulls to remove the paint mask. Carefully remove the cloth from the inside of the grille. If you are using spray paint, apply two light coats. [. . . ] If it is necessary to return your speaker to the factory, please ship it prepaid. After it has been repaired, we will return it freight prepaid in the United States and Canada. Specifications are subject to change without notice. [. . . ]