User manual BOSTON ACOUSTICS SUB10F

[. . . ] Note: The Sub10F is an installed product. Installation should only be attempted by professional installers or those possessing skills in construction, the proper use of hand and power tools, knowledge of local building and fire codes, and a familiarity with the environment below the floor in which the subwoofer will be installed. Placement For maximum bass, place the Sub10F so its vent is near a corner or sidewall and is as close to the main speakers as possible. Floor Register (Not supplied) The Sub10F mounts in the floor directly below a floor register. The register should have a minimum air opening of 3 x 9". [. . . ] Set the equalization switch (EQ-MODE) on the back of the SA1 amplifier to the "FLOOR" position. We recommend the use of 16-gauge or larger speaker wire with both the Sub10F and SA1. Service Access If service is needed, the Sub10F's woofer can be removed through the access panel on the bottom of the subwoofer. If there is a finished ceiling below the Sub10F, ideally a door allowing access to the complete subwoofer enclosure, or at minimum, to the Sub10F's service panel, should be left in the ceiling below. 3 Preparation for Installation 1) Attach the supplied gasket to the subwoofer. 2) After deciding on the location of the Sub10F, use the supplied template to check for the fit of the subwoofer and location of the floor register. It is important to check both below the floor where the Sub10F is to be mounted and in the room where the floor register is to be located. 3) Use drywall or deck screws (not supplied) for mounting the Sub10F. Do not use wood screws. Installation Be sure to mount the Sub10F rigidly to the floor joists, as its tremendous output could cause unwanted vibration if the Sub10F is able to move. Be sure the joists to which the Sub10F is mounted are securely braced against each other so that the distance between them does not change and they are not able to move or shift. Cut the hole in the floor for the floor register. 2) If any nails are protruding from the subfloor above, cut or hammer them out of the way. Note: If there is not going to be ceiling installed in the room below, it is best to mount the Sub10F after construction is complete. If the subwoofer must be installed while construction in the room above is still in progress, cover the hole for the floor register so that construction debris or liquids cannot fall onto the subwoofer. 3) With the hole for the floor register as a guide, hold the Sub10F in place and use the supplied brackets to mark for screw holes. 4) Drill pilot holes in the Sub10F before attaching screws. The Sub10F's cabinet is made of MDF (Medium Density Fiberboard), which can crack if pilot holes are not drilled. 5) The Sub10F's cabinet must be airtight. Seal any unused pilot holes with glue or caulk. [. . . ] This warranty is limited to the Boston Acoustics Sub10F and does not cover damage to any associated equipment. This warranty does not cover the cost of removal, reinstallation, or repair of damage to the installation location caused by either the mounting or removal of the product. This warranty is void if the serial number is defaced or removed. Boston and Boston Acoustics are registered trademarks and DCD is a trademark of Boston Acoustics, Inc. 300 Jubilee Drive Peabody, MA 01960 U. S. A. [. . . ]