User manual BOSTON ACOUSTICS VSI 555W2

[. . . ] The aluminum cup is specially sculpted to eliminate diffraction when the tweeter is pivoted. All VSi models include a boundary compensation switch that allows the installer to shape the sound of each speaker to counteract the effect of being installed too close to a listening area's corner, or too far away for that matter. The VSi speakers are constructed of rugged materials--making them ideal for installations in kitchens or bathrooms. Since the speaker installation is permanent and the furniture placement may not be, you should first determine the best long-term location for the speakers--one that will accommodate future relocation of the furniture in the room, while still allowing for an unobstructed sound path from the speakers to the listening area. [. . . ] Use a #2 Phillips screwdriver and hammer to punch out the knockout from behind. If you are bi-wiring or bi-amplifying your VSi 5835 loudspeakers you must move the jumper on the crossover from the "NORMAL" terminal to the "BIAMP"terminal or you risk damaging your speakers and your amplifier. If the VSi 5835 is installed horizontally, the tweeter/midrange sub-baffle should be rotated so the tweeter and midrange drivers remain vertical. If the speaker is mounted far off-axis, the sub-baffle can be angled toward the prime listening position. Remove the 4 Phillips head screws holding the sub-baffle in place. Rotate the sub-baffle so the tweeter is oriented above the midrange driver, and slide the baffle back into place. The response of a speaker changes when it is mounted close to the boundary junctions of a room (near an adjacent wall or ceiling or close to the corners of the room). Your Boston VSi loudspeakers have been carefully voiced to compensate for these boundary effects. The speaker is mounted less than 18-inches (46cm) from the junction of two surfaces (wall/wall, wall/ceiling or wall/floor). The speaker is mounted less than 24-inches (61cm) from the junction of three surfaces (a room corner). Always turn off the amplifier or receiver when connecting speakers or any other components to the system. This manual assumes the installer possesses skill in the proper use of hand and power tools, knowledge of local building and fire codes, and a familiarity with the environment behind the wall or ceiling in which the speakers will be installed. A utility knife, jig saw or other tool for cutting the required hole in the mounting surface. Make a small hole at the center of the speaker location. Insert a long, bent piece of wire and rotate to confirm that there are no obstructions behind the chosen location. Run the wire from the amplifier location to the cutout. Allow for an extra foot of wire at the cutout. The VSi speaker jack will accept either bare wire up to 12-gauge, or single banana plugs. The VSi 575 and VSi 585 must slide into the wall woofer side first. â· The VSi 555W2 and VSi 5835 slide into the wall long side first. If you wish to paint your speakers or grilles it should be done prior to installation of the grille. Insert the grille into the slots in the baffle by gently applying pressure along the edge. [. . . ] This warranty does not cover the cost of removal or reinstallation. This warranty is void if the serial number has been removed or defaced. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. First, contact the dealer from whom you purchased the speakers. [. . . ]