User manual BOWENS GEMINI 250

[. . . ] · Operate the unit without a safe grounded (earthed) AC supply. Typical Recycle Time Full Power, 230V, 50Hz (117V 60Hz) Modelling Power Control Flash Duration (t=0. 5) (Full power) Flash Power Control Modelling Lamp Ready Indication User Replaceable Flash Tube Photocell Audio Ready Signal Recommended Modelling Lamps Weight Dimensions (l x w x h) DO: · Switch power off and disconnect from the supply before changing modelling bulb or flash tube. · Disconnect the supply before changing the fuse. Never replace with a fuse of a different rating. A spare fuse is fitted in the fuse holder. [. . . ] Gently pull the flashtube assembly out of the unit. To replace the assembly, hold the flashtube as shown and taking care to support both legs of the tube, gently but firmly, push the flashtube into position, and wind the Trigger wire around the flashtube support. Always replace with the correct flashtube assembly, BW-2032 UV coated. BW-2030 Clear (BW-2980 for 750+). Connecting & Using the Esprit Gemini !!!WARNING HIGH VOLTAGE !!! NEVER CONNECT THE ESPRIT GEMINI TO BOTH A MAINS SUPPLY AND A BATTERY SUPPLY AT THE SAME TIME. THIS APPLIANCE MUST BE EARTHED WHEN USED WITH MAINS. DISCONNECT THE MAINS LEAD WHEN CHANGING MODELLING LAMPS & FLASH TUBES. The Esprit Gemini unit may be operated either on a mains supply or with a Bowens battery source such as the Bowens Travel-Pak. For mains operation, the mains switch (page 4) should be in the upper position. For battery operation the switch should be in the lower position. NOTE: When operated from a battery source, the modelling functions are not available. Connect the unit using the appropriate cabling. If using a battery source, ensure the connector locks are fully tightened. Switch the power source on, then switch on the Esprit Gemini. The unit will charge and indicate it is ready for use by illuminating the Green READY light. Press the TEST button to check the unit fires. Battery Solutions The Esprit Gemini Digital is great studio monolight, but what about if you need to work out on location?Thanks to Bowens handy battery packs, your Bowens Esprit Gemini Digital units can leave the studio to go on location anytime, anywhere. Included in Bowens range of battery packs are the Travel-Pak and the larger Travel-Pak+. With a fast / slow charge option to prolong the life of the battery as well as a stylish carry bag offering protection from the elements and up to 3 inches of water; no location photographer should be without these handy packs. Travel-Pak BW7631 Travel-Pak+ BW7638 Also available from Bowens range of battery solutions is the TurboPak; designed to provide power for up to four Bowens Esprit Gemini Units providing up to 1600 flashes on a single charge. Similar in proportion to the Explorer 1500, the TurboPak is just as portable but with the added benefit of being able to power four Bowens Esprit Gemini units, so with four 750Ws you have up to 3000Ws of energy at your disposal. Unlike the Travel-Pak, the TurboPak battery is removable allowing you to charge the battery outside of the unit. Spare batteries are available which means you can charge one battery while using another and then swap them over when used on lengthy or extended photo-shoots. [. . . ] Note: If the unit is subjected to rapid operation over extended periods, it may automatically go into an overheat condition. In this condition, the Green READY lamp will illuminate to indicate the presence of power, while the charging and modelling functions are disabled in order to allow the unit to cool. The unit will automatically resume operation once cooled sufficiently. HINT - In an overheat condition, the unit will typically take 15 minutes to cool down. [. . . ]