User manual BRANDT AD 1036 X

[. . . ] - The hood should never be used over a combustible fuel burning stove (wood, coal, etc). These hoods have been designed for non-commercial use in private homes. With a view to constantly improving our products, we reserve the right to modify their technical, functional or aesthetic characteristics, making any changes to their features considered necessary or desirable in view of technical progress. These hoods are designed exclusively for cooking foodstuffs and drinks. [. . . ] If the instructions for the hob installed under the hood specify a distance of more than 70 cm, this requirement must be respected. - Draw a horizontal line 70 cm minimum from the cooktop. - Draw a vertical line on the wall running from the ceiling to the lower edge of the hood. - Place the mounting hole template against the wall (fig. - Screw up the top two screws of the hood, but not completely - allow them to protrude by 5 mm. - Attach the suction hood to the two screws (fig. - Screw up the two screws at the bottom. Adjust the level of your hood before fully tightening up all four screws. C onnecting up your hood This appliance is delivered with a H 05 VVF power cable with 2 conductors of 0. This must be connected to the 220-240 V single phase mains network via a CEI 60083 standard plug which must remain accessible following installation. We will not be liable in the event of an accident arising following incorrect installation. The fuse for your installation must be 10 or 16A. If the power cable is damaged, call the after sales service department in order to avoid danger. Qxp 18/06/2007 09:05 Page 13 A ssembling the chimney Hood to be used with external evacuation : fig. 4 and 8 - Attach the metal chimney bracket to the wall, also placing this against the ceiling (fig. Take care in aligning the 2 triangular slots on the metal bracket with the vertical line on the wall. - In the case of a flue with a diameter of 125 mm, use the adapter supplied (fig. If your exterior duct is below 125 mm, you must obligatorily connect your hood in recycling mode - Prepare your telescopic chimney taking care to block off the vents (fig. Fit the chimneys into one another as far as they will go. GB - Fit the upper part to the metal bracket. - Adjust the length of the telescopic chimney by bringing down the lower part and fitting it to the top of the hood. To ensure optimal use of your device, we advise that you connect a flue with a diameter of 150 mm (not supplied). [. . . ] Place the carbon filter on the cartridge, on the inner side of the hood. Repeat this operation on all of the cartridges. Blemishes on the hood caused by abnormal use or cleaning with abrasive products which do not cause the appliance to cease functioning or which do not cause it to become unsuitable for use will not be dealt with by the manufacturer. Any repairs must be carried out by a qualified technician. [. . . ]