User manual BRANDT AD 1186 X

[. . . ] τήρας ENEN FR PT DE CZ DK FI NO SE GR 182 18 34 50 66 82 98 116 135 151 As part of our commitment to constantly improving our products, we reserve the right to make changes to them based on technical advances to their technical and functional features and appearance. Warning : Before installing and using your appliance, please carefully read this Guide to Installation and Use, which will allow you to quickly familiarise yourself with its operation. 2 TABLE OF CONTENTS 1 / NOTICES TO THE USER 1 / NOTICES TO THE USER • Safety recommendations _____________________________________ • Safety recommendations _____________________________________ • Environmental protection _____________________________________ • Environmental protection _____________________________________ • Description of your appliance _________________________________ • Description of your appliance _________________________________ 2 / INSTALLING YOUR APPLIANCE 2 / INSTALLING YOUR APPLIANCE • Using the evacuation mode ___________________________________ • Using the evacuation mode ___________________________________ • Using the recycling mode _____________________________________ • Using the recycling mode _____________________________________ • Electrical connections ________________________________________ • Electrical connections ________________________________________ • Assembling the hood ________________________________________ • Assembling the hood ________________________________________ • Assembling the ventilation shaft • Assembling the ventilation shaft º Outdoor evacuation ______________________________________ º Outdoor evacuation ______________________________________ º Recycling _______________________________________________ º Recycling _______________________________________________ 3 / USING YOUR APPLIANCE 3 / USING YOUR APPLIANCE • Description of control panel ___________________________________ • Description of control panel ___________________________________ 4 / CARING FOR AND CLEANING YOUR APPLIANCE 4 / CARING FOR AND CLEANING YOUR APPLIANCE • Cleaning the filter cartridges __________________________________ • Changing the carbon filter ____________________________________ lter ____________________________________ • Cleaning the outer surfaces ___________________________________ • Cleaning the outer surfaces ___________________________________ • Changing the light bulb _______________________________________ • Changing the light bulb _______________________________________ • Maintaining your appliance ___________________________________ • Maintaining your appliance ___________________________________ 5 / TROUBLESHOOTING ___________________________________________ 5 / TROUBLESHOOTING ___________________________________________ 6 / AFTER-SALES SERVICE __________________________________________ 6 / AFTER-SALES SERVICE __________________________________________ EN 20 4 21 5 22 6 23 7 23 7 24 8 25 9 26 10 27 11 28 12 13 29 13 29 14 30 30 14 15 31 16 32 33 17 3 EN 1 / NOTICES TO THE USER Attention Keep this user guide with your appliance. If the appliance is ever sold or transferred to another person, ensure that the new owner receives the user guide. [. . . ] We cannot be held responsible for any accident resulting from an inexistent, defective or incorrect ground lead. The fuse for your installation must be 10 or 16A. If the power cable is damaged, call the aftersales service department in order to avoid danger. Warning If the electrical installation at your residence requires any changes in order to hook up your appliance, call upon a professional electrician. Warning If the hood displays any malfunctions, unplug the appliance or remove the fuse corresponding to the electrical socket where your appliance is plugged in. 8 2 / INSTALLING YOUR APPLIANCE • ASSEMBLING THE HOOD Warning The hood must be installed in compliance with all applicable regulations concerning the ventilation of premises. In France these regulations are described in DTU 61. In particular, the evacuated air should never be conveyed to a duct used to evacuate smoke from appliances that use gas or other combustible fuels. Unused ducts may only be used after approval from a competent specialist. The minimum distance between the cooking surface and the lowest part of the hood must be 70 cm at least. If the instructions for the hob installed under the hood specify a distance of more than 70 cm, this requirement must be respected. EN Pict 1 Fixing to the wall : — Mark a vertical line on the wall centred on the cooktop. € Mark on the wall the three holes that have to be drilled, using the supplied hood suspension hook and observing the recommended distance. € Drill the three 8 mm diameter holes in a suitable position and insert the plugs (part A Pic. € Before fixing the hood, mount the nonreturn valve on the motor outlet -Secure the hood’s fixing support, ensuring that it is perfectly level. 1) — Fix the extendable evacuation sleeve (not included) to the motor outlet without impeding the movement of the non-return valve. € Fit and secure the body of the hood on this support with the screws provided for this purpose. Pict 2 EN 2 / INSTALLING YOUR APPLIANCE • ASSEMBLING THE VENTILATION SHAFT • Outdoor evacuation — Calculate the final height for fixing the duct support U-bracket (part B Pic. 1) — Mark the two holes accordingly — Drill 8 mm diameter holes and secure the duct support bracket, ensuring that it is fixed on the same axis as the hood (part B Pic. 1) — Fix the flat bracket behind the lower duct. Slide the glass in and secure it with the 4 screws with rubber seal (glass safety). € Connect the sleeve to the air outlet to the outside. [. . . ] • The single-pole cut-off device was not activated. 16 6 / AFTER-SALES SERVICE EN Any maintenance on your equipment should be undertaken by : — either your dealer, — or another qualified mechanic who is an authorized agent for the brand appliances. When making an appointment, state the full reference of your equipment (model, type and serial number). This information appears on the manufacturer’s nameplate attached to your equipment. [. . . ]