User manual BRANDT AD1006B,MV

[. . . ] 17 EN 18 As part of our commitment to constantly improving our products, we reserve the right to make changes to them based on technical advances to their technical and functional features and appearance. Warning : Before installing and using your appliance, please carefully read this Guide to Installation and Use, which will allow you to quickly familiarise yourself with its operation. If the appliance is ever sold or transferred to another person, ensure that the new owner receives the user guide. Please become familiar with these recommendations before installing and using your oven. [. . . ] The electrical connections are made before the appliance is installed in its housing. Ensure that: — the electrical installation has sufficient voltage, — the electrical wires are in good condition, — the diameter of the wires complies with the installation requirements. Warning This appliance is delivered with a H 05 VVF power cord that has three- 0. 75 mm2 conductors (neutral , phase and ground). It must be connected to the main power supply (which should be a 220-240 V single phase current) via a CEI 60083 standardised socket that should remain accessible after installation, in keeping with installation guidelines. We cannot be held responsible for any accident resulting from an inexistent, defective or incorrect ground lead. The fuse for your installation must be 10 or 16A. If the power cable is damaged, call the aftersales service department in order to avoid danger. Warning If the electrical installation at your residence requires any changes in order to hook up your appliance, call upon a professional electrician. Warning If the hood displays any malfunctions, unplug the appliance or remove the fuse corresponding to the electrical socket where your appliance is plugged in. 24 2 / INSTALLING YOUR APPLIANCE • ASSEMBLING THE HOOD Warning The hood must be installed in compliance with all applicable regulations concerning the ventilation of premises. In France these regulations are described in DTU 61. In particular, the evacuated air should never be conveyed to a duct used to evacuate smoke from appliances that use gas or other combustible fuels. Unused ducts may only be used after approval from a competent specialist. The minimum distance between the cooking surface and the lowest part of the hood must be 70 cm at least. If the instructions for the hob installed under the hood specify a distance of more than 70 cm, this requirement must be respected. EN Pict 1 Fixing to the wall : — Mark a vertical line on the wall centred on the cooktop. € Mark on the wall the three holes that have to be drilled, using the supplied hood suspension hook and observing the recommended distance. 1) — Drill the three 8 mm diameter holes in a suitable position and insert the plugs. € Before fixing the hood, mount the nonreturn valve on the motor outlet -Secure the hood’s fixing support, ensuring that it is perfectly level. 1) — Fix the extendable evacuation sleeve (not included) to the motor outlet without impeding the movement of the non-return valve. 3) — Fit and secure the body of the hood on this support with the screws provided for this purpose. [. . . ] € CLEANING THE FILTER CARTRIDGES They must be cleaned after approximately 30 hours of use or at least once a month. These filters can be cleaned in a vertical position in your dishwasher. use a brush , hot water and mild detergent. Rinse and dry them thoroughly before returning them to the hood. [. . . ]