User manual BRANDT AD1036W

[. . . ] These hoods are designed exclusively for cooking foodstuffs and drinks. These products do not contain any asbestos based components. Throughout this manual, indicates safety recommendations, indicates advice to help you make the best use of your oven 10 99631294_A_ML. [. . . ] In this case, you should add an active carbon filter which will keep in odours. A ssembling your hood The hood must be installed in conformity with the applicable regulations concerning the ventilation of premises. In France, these regulations are detailed in DTU 61. In particular, the evacuated air must not be channelled into a duct used to evacuate fumes from appliances using gas or other combustible fuels. Disused ducts may only be used after approval from a competent specialist. The minimum distance between the cooking surface and the lowest part of the hood must be 70 cm. If the instructions for the hob installed under the hood specify a distance of more than 70 cm, this requirement must be respected. - Draw a horizontal line 70 cm minimum from the cooktop. - Draw a vertical line on the wall running from the ceiling to the lower edge of the hood. GB - Fit the upper part to the metal bracket. - Adjust the length of the telescopic chimney by bringing down the lower part and fitting it to the top of the hood. To ensure optimal use of your device, we advise that you connect a flue with a diameter of 150 mm (not supplied). Limit the number of angles and bends as far as possible, and keep the length of the flue to a minimum. In the event that the hood will be functioning using exterior evacuation, you should ensure a sufficient inlet of fresh air to avoid a pressure deficiency in the room. - Fit the plastic smoke deflector to the wall also placing this against the ceiling. Take care to centre the deflector vis-à-vis the vertical line drawn on the wall (fig. - Prepare your chimney taking care to place the vents toward the top to ensure that they are visible (fig. - Fit the upper part to the plastic deflector. [. . . ] never use metal scouring pads , abrasive products or excessively stiff brushes. To clean the body and the lighting port, you should use only commercial household cleaning products diluted in water and then rinse using clean water, drying with a soft cloth. Place the carbon filter on the cartridge, on the inner side of the hood. [. . . ]