User manual BRANDT AD1188X

[. . . ] € Repairs must only be carried out by an approved specialist. € Always unplug the hood before cleaning it or performing other maintenance acts. € Provide adequate ventilation for the room in the case of simultaneous use of the hood and other appliances powered by an energy source other than electricity. This will prevent the hood from aspirating the combustion gases. [. . . ] Help recycle it and protect the environment by dropping it off in the municipal receptacles provided for this purpose. — Your appliance also contains a great amount of recyclable material. It is marked with this label to indicate the used appliances that should not be mixed with other waste. This way, the appliance recycling organised by your manufacturer will be done under the best possible conditions, in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment. Contact your town hall or your retailer for the used appliance collection points closest to your home. € We thank you doing your part to protect the environment. warning Installation should only be performed by installers and qualified technicians. Warning Remove the protective film from the cartridge filter before use. 5 EN 1 / NOTICES TO THE USER • DESCRIPTION OF YOUR APPLIANCE 6 2 / INSTALLING YOUR APPLIANCE • ENVIRONMENTAL COOKER HOOD • INSTALLING YOURPROTECTION — The ceiling must can bear at least 40kgs weight, and the thickness of the ceiling must be 30MM, see pic 2, drill 1*170mm round hole in the ceiling. EN — According to the hanging board, drill 12 holes in the ceiling, see pic 2, 12pcs of ST6*40mm big flat screws will be used to fix the hanging board on the ceiling, and then 8pcs of M4*10 screws and M4 nut with gasket will be used to connect the angle iron into the hanging board, see pic 1, calculated the length of the angle iron, and 16pcs M4*10 big flat screws and M4 nut with gasket will be used to connect the angle iron and another angle iron ( the overlap length of angle iron can not less 100MM) Pic 1 Pic 2 — Let the one side of the extensible pipe go outside through the hole of 170MM, see pic 3. Pic 3 — 4pcs ST4*8 big flat screws will be used to connect the internal chimney into the hanging board, then put one the external chimney, two hooks will be used to put up the external chimney in order to the next installation, see pic 4. It should be changed at least every four months. € CHANGING THE LIGHT BULB Take the bracket and glass off and then take the broken light bulb off, See Pic 14. Fix the new light bulb, glass and bracket on. Pic 14 Attention Before changing the lights, ensure that the appliance is not live. € INSTALL THE T-SHARP OUTELT — Fix the outlet outlet on the T-sharp, see Pic 15. € Fix the T-sharp outlet on the inside chimney, see Pic 16. Pic 15 Pic 16 10 4 / CARING FOR AND CLEANING YOUR APPLIANCE Warning EN Before carrying out any work, the power supply to the hood must be turned off, either by unplugging it or by using the circuit breaker switch. • MAINTAINING YOUR APPLIANCE MAINTENANCE WHAT TO DO Never use metal scouring pads , abrasive products or excessively stiff brushes. Top surface and accessories PRODUCTS / ACCESSORIES TO USE To clean the body and the lighting port, you should use only commercial household cleaning products diluted in water and then rinse using clean water, drying with a soft cloth. Use a commercial household cleaning product then rinse abundantly and dry. These filters can be cleaned in a vertical position in your dishwasher. [. . . ] • The carbon filter is not worn (hood operating in recycling mode). Ensure that: • The power is not cut off. The hood stopped working • The single-pole cut-off device was not activated. EN 6 / AFTER-SALES SERVICE Any maintenance on your equipment should be undertaken by: - either your dealer, - or another qualified mechanic who is an authorized agent for the brand appliances. [. . . ]