User manual BRANDT AD658XC1

[. . . ] EN 6 / AFTER-SALES SERVICE Any maintenance on your equipment should be undertaken by: - either your dealer, - or another qualified mechanic who is an authorized agent for the brand appliances. When making an appointment, state the full reference of your equipment (model, type and serial number). This information appears on the manufacturer's nameplate attached to your equipment. Tijdens het telefoneren, dient u de complete referentie op te geven van uw machine (model, type, serienummer). [. . . ] Qxp 19/01/2006 11:15 Page 55 2 / INSTALLING YOUR APPLIANCE EN - The appliance must be unplugged during installation or when any repairs or maintenance work is being performed. - Ensure that the network voltage corresponds to the voltage noted on the identification plate located inside the hood. - If the electrical installation at your residence requires any changes in order to hook up your Appliance, call upon a professional electrician. - If the hood is being used in evacuation mode, do not connect the appliance to a combustion gas exhaust duct (boiler, chimney, etc. ) or to a CMV (controlled mechanical ventilation) system. - Under no circumstances should the exhaust duct empty into the attic. - Install the hood at a safe distance of at least 70 cm from an electric, gas or combined cooking hob. € USING THE EVACUATION MODE If you possess an outlet to the exterior (fig. 1) Your hood can be connected to this outlet using a flue (minimum diameter Ø mm that is enamelled, in aluminium, flexible or made of inflammable material). If your flue is less than 125 mm in diameter, you must use the recycling mode. 1 • USING THE RECYCLING MODE If you do not possess an outlet to the exterior (fig. 1) on the wall, superimposing the line that represents the hood's axis over vertical line B (fig. 1) against the wall flush with the ceiling. € Screw in the top two screws for the hood (D/fig. 1), leaving 5 mm sticking out from the wall. € Hang the suction hood on the two screws (fig. € Screw in the bottom two screws (E/fig. 2 Tip Adjust the level of your hood before fully tightening up the four D and E screws. 1), attach the metal chimney bracket against the wall, flush with the ceiling for support. € Mount the back-flow valve near the motor outlet (fig. This back-flow valve makes it possible to block the entry of air from the outside. € If a 125 mm flue is being installed, use the adapter provided (fig. [. . . ] Warning Failure to respect the guidelines for cleaning the appliance and filters may cause fires. Please carefully adhere to the maintenance recommendations. € CLEANING THE FILTER CARTRIDGES They must be cleaned after approximately 30 hours of use or at least once a month. These filters can be cleaned in a vertical position in your dishwasher. [. . . ]