User manual BRANDT AD769BE1

[. . . ] Tijdens het telefoneren, dient u de complete referentie op te geven van uw machine (model, type, serienummer). Qxp 11/12/2006 16:19 Page 34 FR 02 EL 18 EN 34 NL 50 PT 66 Dear Customer, You have just acquired a BRANDT hood and we would like to thank you. We have invested all our dedication and know-how in this appliance so that it would best meet your needs. With innovation and performance, we designed it to be always easy to use. [. . . ] Qxp 11/12/2006 16:19 Page 39 2 / INSTALLING YOUR APPLIANCE EN - The appliance must be unplugged during installation or when any repairs or maintenance work is being performed. - Ensure that the network voltage corresponds to the voltage noted on the identification plate located inside the hood. - If the electrical installation at your residence requires any changes in order to hook up your Appliance, call upon a professional electrician. - If the hood is being used in evacuation mode, do not connect the appliance to a combustion gas exhaust duct (boiler, chimney, etc. ) or to a CMV (controlled mechanical ventilation) system. - Under no circumstances should the exhaust duct empty into the attic. - Install the hood at a safe distance of at least 70 cm from an electric, gas or combined cooking hob. € USING THE EVACUATION MODE If you possess an outlet to the exterior (fig. 1) Your hood can be connected to this outlet using a flue (minimum diameter Ø mm that is enamelled, in aluminium, flexible or made of inflammable material). If your flue is less than 125 mm in diameter, you must use the recycling mode. 1 • USING THE RECYCLING MODE If you do not possess an outlet to the exterior (fig. 1) on the wall, superimposing the line that represents the hood's axis over vertical line B (fig. 1) against the wall flush with the ceiling. € Screw in the top two screws for the hood (D/fig. 1), leaving 5 mm sticking out from the wall. € Hang the suction hood on the two screws (fig. € Screw in the bottom two screws (E/fig. 2 Tip Adjust the level of your hood before fully tightening up the four D and E screws. 1), attach the metal chimney bracket against the wall, flush with the ceiling for support. € Mount the back-flow valve near the motor outlet (fig. This back-flow valve makes it possible to block the entry of air from the outside. € If a 125 mm flue is being installed, use the adapter provided (fig. [. . . ] € CLEANING THE FILTER CARTRIDGES They must be cleaned after approximately 30 hours of use or at least once a month. These filters can be cleaned in a vertical position in your dishwasher. use a brush , hot water and mild detergent. Rinse and dry them thoroughly before returning them to the hood. [. . . ]