User manual BRANDT AE203BE1

[. . . ] When making the electrical connections, check that the current socket has a ground connection. The following warning is valid in the United Kingdom only: in case your cable is not furnished with a plug, read the following instructions; as the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: ?the wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the ], or coloured green or letter E or by the earth symbol [ green and yellow; ?the wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black; ? [. . . ] To clean painted appliances on the outside, use a cloth dipped in lukewarm water and neutral detergent. To clean steel, copper or brass appliances on the outside, it is always best to use specific products, following the instructions on the products themselves. To clean the inside of the appliance, use a cloth (or brush) dipped in denatured ethyl alcohol. 1) the air and steam conveyed by the hood are purified by the charcoal (or polyurethane) filters and recirculated in the room. 2) the steam and kitchen smells are conveyed directly to the outside through a disposal duct fitted in the wall/ceiling. Therefore, use of charcoal (or polyurethane) filters are not necessary. INSTALLATION To facilitate installation, remove the grille or the grease filters (depending on the model bought) and disassemble the front door. Door disassembly: open the door by pulling it forwards; operating on the inside of the hood remove the 2 screws D as illustrated in Fig. Hold the tab L down and remove the door from the guides. Grille disassembly: open the door pulling it forwards and push the 2 plastic catches upwards (Fig. Grease filters disassembly: open the door pulling it forwards; in correspondence to the handle, push the catch upwards and extract the filter (Fig. When the installation has been completed, remount the front door and make the electrical connection. OPERATION IMPORTANT: to ensure correct operation of the grease filter LED visual alarm, ALWAYS switch off the motor by pressing button B = motor ON/OFF switch. It is not therefore enough to switch off the machine by closing the panel. For all versions the motor is operated automatically by opening and closing the front door. C = speed II switch; pressed a second time, the timer is activated and the motor turns off after 10?: the relevant LED flashes continuously. D = speed III switch; the timer acts as for switch C. E = speed IV switch; the timer acts as for switch C. 17): A = light switch; position 0: light off; position 1: light on. Grease filter/s: Depending on the version, the hood features different types of grease filters: Modular metal filters (of the type shown in Fig. 18): these filters must be cleaned about every 30 hours of operation (all the LEDs flash simultaneously). To remove the filters: open the door pulling it forwards and remove the filters pushing the catch upwards in correspondence to the handle. [. . . ] To remove the synthetic filters: open the door pulling it forwards and push the 2 plastic catches upwards (Fig. With the filtering version also the polyurethane filter needs to be removed. In case of using the hood in the filtering version, the charcoal (or polyurethane) filters will need to be replaced depending on use, on average every six months. The filtering hood is supplied with different types of charcoal : Round charcoal filters (Fig. [. . . ]