User manual BRANDT BFK747YSW

[. . . ] Dear Customer, You have just purchased a BRANDT product and we thank you for your trust. We designed and manufactured this product with you, your lifestyle and your needs in mind, in order to best meet your expectations. We have put into it our expertise, our spirit of innovation and all the passion which has driven us for over 60 years. We make every effort to ensure our products better meet your requirements, and our Customer Relations Department is at your disposal and will be happy to hear any questions or suggestions you may have. [. . . ] Don't put hot food in the appliance. Don't pack food close together as this prevents air circulating. Make sure food don't touch the back of the compartment(s). If electricity goes off, don't open the door(s). Don't keep the door(s) open for too long time. Don't set the thermostat on exceeding cold temperatures. Some accessories, such as drawers, can be removed to get larger storage volume and lower energy consumption. This appliance does not contain gasses Which could damage the ozone layer, in The appliance shall not be Discarded together with the urban refuse and Flammable gases: the appliance shall be Disposed according to the appliance Avoid damaging the cooling unit, Used on this appliance marked by the symbol The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local council, your household waste disposal service or the shop where you purchased the product. packaging materials The materials with the symbol are recyclable. Note : Above picture is for reference only. Pick out the screws on the freezer cabinet and door by tools, total 7 pieces and Pick out the handle base with lock handle cover , and lock ring Fix the handle base on the door by driving 5 Fix the handle cover Pieces of screws picked Step 4 Fix the lock ring on the freezer cabinet using the balanced 2 screws note: If the lock ring failed to hold the lock when installing handle, please unscrew the round head screws on the back of door and adjust the position of door upper and lower. Then drive the screw to fix the handle Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: The appliance should be installed well away from sources of heat such as radiators' boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm. Ideally, however, the appliance should not be positioned below overhanging wall units. Accurate leveling is ensured by one or more adjustable feet at the base of the cabinet. It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation. electrical connection Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. The power supply cable plug is provided with a contact for this purpose. [. . . ] Remove the drain plug from the inside of the freezer. To defrost faster keep the freezer door open. For draining, place a tray beneath the outer drain plug. This will let the water flow out in the tray. [. . . ]