User manual BRANDT BIL2212SW

[. . . ] Kontakt rådhuset for at få oplysninger om bortskaffelse af denne type apparater. Når du ringer, skal du referere til apparatets model, type og serienr. Dear Customer, You have just acquired a BRANDT refrigerator and we would like to thank you. We have invested all our dedication and know-how in this appliance so that it would best meet your needs. [. . . ] It is also possible to reverse the direction in which the freezer compartment door opens. Pull back the removable hinge with the help of a screwdriver and remove the door. Unclip the hole cover and fix it in the opposite hole. Insert the upper shaft in the corresponding hole. Insert the removable hinge in the the lower shaft of the door, then clip it into the corresponding hole. Size of the space For safety reasons, ventilation must be provided as indicated in the diagram opposite. Warning: do not obstruct the ventilation openings. It is also necessary that the space Has a ventilation opening with the Insert the compressible gasket between the appliance and the furniture. Insert the caps (C-D) on the fin stops and in the holes of the hinges. Depending on the model, apply the ventilation grill (B) and the hinge cover. Insert the appliance into the space against the internal partition, corresponding to the hinging side of the door, so the upper cover cap is just proud (1) and the bottom hinge is aligned with the partition of the furniture (2). Fix the appliance in place with the 6 screws provided for this purpose. Separate the parts Ha, Hb, Hc, Hd as shown in the drawing. Place the runners (Ha) on the internal part of the furniture support and mark the position of the external holes. After trying out the holes, fix the runners with the screws provided. Click the cover (Hc) onto the runner (Ha). (continued) Open the door of the appliance and of the furniture about 90°. Insert the bracket (Hb) into the runner (Ha). Hold appliance and furniture doors together and mark the position of the holes as shown in the drawing. Remove the bracket and make holes 8 mm from the outer edge of the door using a drill fitted with a 2 mm drill bit. Put the bracket back on the runner and fix it with the 8 screws provided. Use the set of oval holes to align the door of the furniture if necessary. [. . . ] We recommend that you clean and disinfect your appliance regularly · Clean the interior with water and bicarbonate of soda using a sponge or a dishcloth to prevent any bad smells occurring. Never, under any circumstances, use solvents or abrasive detergents because these could damage the interior of your appliance. Also do not put any of the interior's accessories in the dishwasher. We recommend that you dust the back of the appliance with a cloth once a year because if it is dirty, your refrigerator's output reduces and its consumption increases. [. . . ]