User manual BRANDT BPI6210B

[. . . ] € The appliance must be installed by an authorised installer who will follow the manufacturer’s instructions and diagrams. € The electrical installation must be suitably dimensioned for the maximum power indicated on the reference plate and the plug must have the regulatory earth connection. € If the power cord is damaged, it should be replaced by the manufacturer or by your after-sales service or similar qualified personnel to prevent possible hazards. € WARNING: If the glass surface cracks or breaks, disconnect it from the mains immediately to prevent a possible electric shock. [. . . ] € The heat elements should not be operated without a receptacle. € Only use the appliance for cooking food. € Do not apply cold water directly onto the hob when it is hot. Press for 3 seconds to switch on the hob. A will appear for each of the different cooking zones. 0 Identify the model of your hob (“a”, “b”, “c”, “d”) by comparing the number and layout of the elements on your appliance with that shown in the illustrations. Note: If the child safety lock is on, you will need to switch it off by pressing the key for 3 seconds before making your selection. Switch on the zone where you have placed the container by pressing the corresponding key (2. : If you take longer than 10 seconds to select the element, the hob will automatically turn itself off, as a safety measure. After choosing the heat to switch on the double setting, press zone. Model (a) : First switch on a cooking zone, and you will then press 1, 2, 3. 9, key of the zone you want to press the (2. You will see a time with , and confirm by pressing the timer key again (2. A dot next 13 e n g l i s h to the temperature shows that the zone is in timer mode. The hob will beep and the • symbol will appear to warn you that the time is up. : The timer will automatically turn itself off if you take longer than 10 seconds to select the time. Observations on timing: If the power level is 9, the maximum time for the timer will be 60 min. Once the time has passed, the alarm will sound until you press any key. Make sure that the zone you are going to switch on corresponds to the zone you want to use (2. Turn the control to the position required and the pilot light will come on (2. This also show the residual heat when the zone is switched off. Select the power of the element you want to turn off. [. . . ] 2) • In electronic models, if you hold down any of the sensors for too long, the appliance will stop working and will start beeping. € Aluminium receptacles are not advisable as they can stain the glass, unless they have a stainless steel protective base. 14 4 Environment The hob has been designed with protection of the environment in mind. Use the adequate power for each cooking operation and select the receptacles of a suitable size for the food you are going to prepare. [. . . ]