User manual BRANDT BST524SW

[. . . ] This appliance complies with the European directives. For your safety and in order to use your appliance correctly, carefully read these instructions (including the warnings and useful advice), before installation and first use. To avoid damaging the appliance and unnecessary injury, it is important that the persons who use the appliance fully understand how it works and the safety instructions. Always keep these instructions close to the appliance so that they can accompany it in the event of resale or a change of house. [. . . ] Never pull on the power cord, but only on the plug itself. Note: Above picture is for reference only. To take the door off, it is necessary to tilt the unit backwards. You should rest the unit on Something solid so that it will not slip during the door reversing process. All parts removed must be saved to do the reinstallation of the door. Do not lay the unit flat as this may damage the coolant system. Unscrew top hinge and then remove door and place it on a soft pad to avoid scratch. Then remove the door and place it on a soft pad to avoid scratch. Move door holder from left side to right side. Move hinge hole cover from left side to right side. Then remove the adjustable feet from Note: remove this screw if it presents both side. Unscrew and remove the bottom hinge pin, turn the bracket over and replace it. Refit the bracket fitting the bottom hinge pin. Ensure the door is aligned horizontally and vertically, so that the seals are closed on all sides before finally tightening the top hinge. Put the top cover and fix it with 2 screws on the back. Keep at least 50mm gap at two sides and back. levelling the unit To do this adjust the two levelling feet at front of the unit. If the unit is not level, the doors and magnetic seal alignments will not be covered properly. Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm. Ideally, however, the appliance should not be positioned below overhanging wall units. [. . . ] Clean drain hole To avoid defrost water overflowing into the fridge, periodically clean the drain hole at back of fridge compartment. Use a cleaner to clean the hole as showed in right picture. 1) If the condenser is at back of appliance. X Do not allow such substances to come into contact the appliance parts. [. . . ]