User manual BRANDT EFE730FB,MV

[. . . ] Rather than just throwing these materials away, please ensure they are offered for recycling. It should be unplugged or disconnected from the mains electricity supply by a competent person. The plug must be rendered useless and the cable cut off directly behind it to prevent misuse. See the "Warning and Safety" section of this booklet for further details. Energy saving tips To avoid unnecessarily long drying times and high consumption of energy: ­ Make sure that your laundry is thoroughly spun before drying. [. . . ] Condensed water can be put to household use (e. g. To ensure that any residual particles of fluff in the condensed water are removed before use, pass it through a fine sieve or paper filter first. ^ Pull out the container. ^ Hold it at the front and towards the back and keep it in a horizontal position when carrying it. 21 Cleaning and care Cleaning the fluff filters The fluff which is created by the drying process is collected by the fluff filters in the door and the door opening. Clean the filters after each drying programme*. Cleaning them whilst dry Tip: You can also use a vacuum cleaner to remove the fluff. ^ Use your fingers to remove the fluff from the surface of the filter. ^ Remove any fluff from the hollow part of the door opening. You could also use a cleaning brush which is available as an optional extra from your Miele dealer or the Miele Spare Parts Department, or use a vacuum cleaner. ^ Also clean the door seal (2) with a damp cloth. ^ Once clean, push the filter back into the door holder until it clicks into position. Ensure it is facing the correct way. ^ Open the door and pull the fluff filter (1) out of the door as illustrated. ^ Use your fingers or a vacuum cleaner to remove the fluff from the two fluff filters in the door opening. ^ Remove it by pulling it diagonally upwards. Removing the condenser unit ^ Open the service panel. Hold the panel securely when doing this. ^ Now remove the panel by pulling it diagonally upwards and place it to one side. ^ Turn the lever on the condenser unit upwards to the vertical position. 25 Cleaning and care If you cannot see any fluff: ^ Replace the condenser unit (see following page). If you can see some fluff: ^ Clean the condenser unit as described below. Cleaning the condenser unit ^ When rinsing the condenser unit, make sure you position it as shown in the next two illustrations. ^ Pull the condenser unit out of its housing by the handle. Checking the condenser unit ^ Use a shower head or similar to rinse the unit out as shown. ^ Hold the condenser unit up to the light as shown. ^ Check to see if there is any fluff inside it. The arrows in the illustration above indicate where to look. 26 Cleaning and care Replacing the condenser unit ^ With the handle facing upwards, push the condenser unit back into position in its housing. ^ Turn the lever down to the horizontal position, making sure that the hook on the lever clicks into the groove. When replacing the inner cover after cleaning, ensure that the rubber seal fits correctly into the groove. [. . . ] F Switch the machine off with the I-On/0-Off button. The setting you have selected is now stored in memory. You can change it again at any time. 49 Programmable functions Keypad tone An audible tone sounds each time a button is pressed. Follow steps A to F to programme and store in memory. [. . . ]