User manual BRANDT GE2300B

[. . . ] Thank you for buying a BRANDT product and for your confidence in our company. This product has been designed and manufactured for you considering your lifestyle and your requirements, so that it meets your expectations in the best way possible. We have invested it with our expertise, spirit of innovation and all the enthusiasm which has driven us for more than 60 years. So that we are always able to satisfy your requirements as well as possible, our customer service is available, ready to listen and answer all your questions or suggestions You can also visit our website www. [. . . ] your appliance also contains various recyclable materials. Thus it is stamped with this logo to indicate to you that used appliances should be mixed with other waste. The recycling of appliances organised by your manufacturer will therefore be carried out in the best possible conditions, in compliance with the European directive in force concerning electrical and electronic equipment waste. Contact your Town Hall or your retailer to find out where the points for the collection of used machines nearest to your home are. Thank you for helping to protect the environment. Caution: Check that your machine has not been damaged during transport (door or seals distorted, etc. If you note any damage whatsoever before use, do not install the oven if it is damaged and contact your retailer. Remove the packaging and put the accessories aside. Control Panel: Remove the protective film from the surface of the control panel. Do not remove the light brown Mica coating which is found in the cavity of the oven and which protects the magnetron. Leave at least 30 cm of free space above the oven and 20 cm at the sides (Fig 1). Do not obstruct the air vents as you risk early damage to your machine. It is essential to use a socket with an earthing terminal connected in compliance with the safety standards in force. In your electrical installation provide a user-accessible device which must be able to separate the machine from the mains, the contact opening of which is at least 3 mm on all poles. If the power cable is damaged it must be replaced by the manufacturer, its after-sales service or any other similarly qualified person to avoid any danger. Check that: - the power of the installation is sufficient. - the mains leads are in good condition. - the diameter of the wires complies with the installation rules. - your installation is fitted with 16 ampere heat protection. If in doubt please consult your electrician. The electrical connection must be carried out before placing the machine in its final position. Electrical safety must be ensured by a correct connection. [. . . ] If the door or door hinge are damaged, the oven should not be used until it has been repaired by an authorised person. Do not clean the appliance with a steam cleaner. The use of abrasive products, alcohol or thinner is not recommended; they may damage the appliance. In the event of odour or caked-on dirt, boil water with lemon juice and vinegar in a cup for two minutes and clean the insides with a bit of dishwashing liquid. [. . . ]