User manual BRANDT HCL90X

[. . . ] It is therefore advisable to ensure the room contains air taps able to ensure a steady flow of fresh air. This appliance has such technical particulars that it belongs to class II insulation, therefore it must not be earthed. The following warning is valid in the United Kingdom only: As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: – the wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black; – the wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red; – neither wire is to be connected to the earth terminal of a three-pin plug. When making the electrical connections, check that the voltage values correspond to those indicated on the data plate inside the appliance itself. [. . . ] In case your appliance is not furnished with a non separating flexible cable and has no plug, or has not got any other device ensuring omnipolar disconnection from the electricity main, with a contact opening distance of at least 3 mm, such separating device ensuring disconnection from the main must be included in the fixed installation. Always switch off the electricity supply before carrying out any cleaning or servicing operations on the appliance. Vegetal charcoal fiber panel and recirculated around the room by the front fissures. ATTENTION: For the filtering version it is absolutely necessary to use the special active vegetal charcoal fiber panel whereas for the ducting version it is not. OPERATION -------------------------------------------------The hoods are provided with the following type of controls: Controls of Fig. Position 1-2-3: motor first, second and thrid speed motor on. c = warning light: indicates motor operation. Filtering/ducting conversion: The conversion can be done in the inside of the appliance. 9) is completely unscrewed, so that the inside valve let the air to be conveyed again into the room throuth the slots. insert the activated charcoal fiber panel (Fig. Once the apparatus is hooked, fix it definitively to the wall using the two other screws and the holes made at its bottom (Fig. To avoid damage make exclusive use of the holes already prepared on the hood. Wall cupboard fitting Using the appropriate drilling jig make the four fixing holes into the bottom of the wall cupboard and cut the air venting hole if the hood is a ducting version one (for the filtering version this hole is not necessary). Holding the hood against the bottom of the cupboard fix it to it by means of the supplied four screws (Fig. IMPORTANT: Check the position of screw A (Fig. For the ducting version screw A must be completely screwed; for the filtering version the screw must be completely unscrewed to let the sucked air to get out through the top fissures. USE --------------------------------------------------Avoid using materials which could cause spurts of flame (flambées) near the appliance. When frying, take particular care to prevent oil and grease from catching fire. Already used oil is especially dangerous in this respect. To avoid possible risks of fire always comply with the indicated instructions when cleaning anti-grease filters and when removing grease deposits from the appliance. [. . . ] Already used oil is especially dangerous in this respect. To avoid possible risks of fire always comply with the indicated instructions when cleaning anti-grease filters and when removing grease deposits from the appliance. mAINTENANCE --------------------------------------------------Thorough servicing guarantees correct and long-lasting operation. Use lukewarm water and neutral detergent to clean painted appliances. [. . . ]