User manual BRANDT PRO251RC

[. . . ] EN 6 / AFTER-SALES SERVICE Any maintenance on your equipment should be undertaken by: - either your dealer, - or another qualified mechanic who is an authorized agent for the brand appliances. When making an appointment, state the full reference of your equipment (model, type and serial number). This information appears on the manufacturer's nameplate attached to your equipment. Tijdens het telefoneren, dient u de complete referentie op te geven van uw machine (model, type, serienummer). [. . . ] During build-in and maintenance operations, the appliance must be unplugged from the electrical grid; fuses must be cut off or removed. The electrical connections are made before the appliance is installed in its housing. Ensure that: - the electrical installation has sufficient voltage, -the electrical wires are in good condition - the diameter of the wires complies with the installation requirements. Your oven must be connected with a power cord (standardised) with three 1. 5 mm2 conductors (1 ph +1 N + ground) that must be connected to a monophase 220-240 V~ net23 work via a CEI 60083 standardised receptacle (1 ph +1 N + ground lead) or an all-pole cut-off device, in compliance with installation regulations. Warning The safety wire (green-yellow) is con nected to the appliance’s terminal and must be connected to the ground lead of the electrical set-up. In the case of a hook-up with electrical outlet, it must be accessible after installation. The fuse in your set-up must be 16 amperes. If the power cable is damaged, it must be replaced by a cable or a special kit available from the manufacturer or its After-Sales Service Department. Qxp 12/01/2007 15:14 Page 24 EN 2 / INSTALLING YOUR APPLIANCE Warning We cannot be held responsible for any accident resulting from an inexistent, defective or incorrect ground lead. If the electrical installation at your residence requires any changes in order to hook up your Appliance, call upon a professional electrician. If the oven malfunctions in any way, unplug the appliance or remove the fuse corresponding to the sector there the oven is hooked up. € CHANGING THE POWER CORD — The power cable (H05 RR-F, H05 RN-F ou H05 VV-F) must be of sufficient length to be connected to the build-in oven while it sits on the floor in front of the cabinet. To do this the appliance must be disconnected from the electrical network: — Open the inspection flap located at the lower right of the back cover by unscrewing the two screws, then pivot the inspection flap. € Strip 12 mm along each wire of the new power cable. — Carefully twist together the strands. € Loosen the screws from the terminal board and remove the power cord to be replaced. € Introduce the power cable through the side of the cover in the cable clip located to the right of the terminal board. € All the strands of the electricity wires must be captured under the screws. — The phase wire on the L terminal. € The green-yellow coloured ground wire should be connected to the terminal . — The neutral conductor (blue) on the N terminal. [. . . ] ➡ Check your oven's electrical connection. The phase conductor L (black) must be connected to the L - The oven is not connected phase terminal of your connection box correctly. The N neutral conductor (blue) must be connected to the N neutral ground lead of your connection box or your power plug. The oven light is dimly lit when the oven is switched off. [. . . ]