User manual BRANDT TE1417B

[. . . ] 000 euros RCS NANTERRE 801 250 531 22 FR 02 EN 23 Dear Customer, You have just acquired a BRANDT hob and we would like to thank you. We have invested all our dedication and know-how in this appliance so that it would best meet your needs. With innovation and power, we designed it to be always easy to use. In the BRANDT product line, you will also find a wide range of ovens, microwaves, ventilation hoods, ranges, dishwashers, washers, driers, fridges and freezers, that you can coordinate with your new BRANDT hob. [. . . ] Make the connection directly to the end of the elbow fitted on the appliance. € Connection with a flexible metal hose (stainless steel) with screw-on mechanical connectors (compliant with NF D 36-121 standard) whose service life is unlimited (Fig. € Connection with a flexible rubber hose reinforced with screw-on mechanical connectors (compliant with the NF D 36-103 standard) whose service life is 10 years (Fig. Warning When connecting your hob’s gas supply, if you have to change the direction of the elbow fitted on the appliance: x Change the gasket. Screw on the elbow’s nut, careful not to exceed a torque of 17 N. € Using the wrench provided, unscrew the injectors located under each crucible and remove them (Fig. € Replace with the corresponding gas injectors, in compliance with the placement of the injectors and the table of gas properties at the end of this section; to do so: — First screw them in manually until the injector locks into place. € Apply the wrench to the injector as far as it will go. € Draw a line on the burner plate using a pencil at the place indicated (Fig. € Turn the wrench clockwise until the line appears on the other side(Fig. 02 Warning Exceeding this limit may damage the product. € Reposition the burner heads, burner covers and pan supports on the hob. 03 32 1 / INSTALLING YOUR APPLIANCE • Adjust the hob connections: they are located underneath the knobs (Fig. € Remove the knobs and the gaskets by pulling them up. - Switching from natural gas to butane/ propane Knob - With a small flat-head screwdriver, screw in all the way the brass (yellow) burner power screws(Fig. - Replace the gaskets and the knobs, paying careful attention to their direction and ensuring that the knobs are pushed in all the way. 05) , using a small flat-head screwdriver, by turning two times counterclockwise. - Replace the knob, - Light the burner in maximum heat mode, then turn down to reduced heat mode. - Remove the knob again, then turn the burner power screws clockwise until it reaches the lowest possible setting that does not extinguish the flame. - Make several attempts to shift from the maximum flow rate to the minimum: the flame should not go out; if it does, unscrew the burner power screw so as to obtain good flame retention during these position switches. tap axis Burner power adjustment screw Fig. 05 33 1 / INSTALLING YOUR APPLIANCE • Markings on the injectors MARKINGS ON THE INJECTORS The adjacent table shows where the injectors are positioned on your appliance according to the type of gas used. [. . . ] The lighting function is centralised and controls all of the burners simultaneously. Check that the gas inlet pipe is not pinched. Check that the length of the gas inlet pipe is less than two meters. If you have gas in a cylinder or tank, check that it is not empty. [. . . ]