User manual BRANDT TE214WS1

[. . . ] 42 Which pans are best adapted for use on the electric hotplate?Minor troubleshooting Gas-cooking guide Electric hotplate-cooking guide 43 44 45 45 In this Manual, displays safety instructions displays tips and hints 25 99625732_ML_B. qxd 16/12/02 11:04 Page 26 Editorial Dear Customer , Thank you for buying a BRANDT hob. Our design staff have produced a new generation of kitchen equipment, to make everyday cooking a pleasure. [. . . ] To avoid this, check that there are no heat-producing devices nearby. Screw on the connector with a torque not exceeding 2. Qxd 16/12/02 11:05 Page 35 Installing your hob in all simplicity Changing the type of gas supply ● Preliminary remarks Your hob is delivered regulated for natural gas. The injectors for adapting the hob for use with butane or propane are in the wallet containing the instructions, together with the adaptor and the sealing washer. please see the corresponding paragraph on "Gas Connections". Every time you change your gas supply, mark the square on the label in the wallet that corresponds to the new type of gas (See "Gas Rating" in this chapter). Qxd 16/12/02 11:05 Page 36 Installing your hob in all simplicity Changing the type of gas supply (cont'd) When carrying out this operation, you should successively: ➊ Adapt the gas connection ❷ Change the injectors ❸ Adjust the retarder on the taps ➊ ADAPT THE HOB CONNECTION to the new gas adjustment. CHANGE THE INJECTORS in the following way: • Remove the supports, and all the burner caps and heads. € Using the spanner supplied, unscrew the injectors at the bottom of each dish and remove them (fig 1). - Replace these with the injectors supplied in the wallet, in accordance with the gas rating table at the end of the chapter; to do this: ➪ Screw in the injectors by hand until they are tight. ž Put the spanner well onto the injector. € Your hob is equipped with an automatic lighting system integrated into each control knob. € To ignite a burner, press down and turn the knob anti-clockwise until it is pointing to the maximum position . This will trigger off a series of sparks that will light up the burner. € Adjust the flame to the height your require by turning the control knob between the and symbols. A ● Lighting a hob fitted WITH DEVICE (depending on model) • The safety system for the burners is a metal rod next to the flame. € Choose the gas burner you need using the symbols at the side of each control knob; (E. A SAFETY • Each burner is controlled by a tap fitted with a safety system, which cuts the gas off automatically if ever the flame goes out by accident (overflowing, drafts, etc. € Your hob is equipped with an automatic lighting system integrated into each control knob. € To ignite a burner, press down and turn the knob anti-clockwise juntil it is pointing to the maximum position . € Adjust the flame to the height your require by turning the control knob between the and symbols. To set off the safety system, keep the knob pressed completely down for a few seconds after the flame has lit up. [. . . ] - Check that the sealing rings have not come out of place. The lighter system is centralised, and all the burners spark at the same time. When you only press down one control knob all the burners spark. Sparking takes place but the burners do not light up. [. . . ]