User manual BRANDT TV1205B

[. . . ] If you sell or give the appliance to another person, make sure you also pass on the user manual. Read these instructions carefully using and installing the appliance. They are designed to protect your own and others’ safety. € The mains circuit to which the hob is connected must have a omnipolar cut-off switch with a contact opening distance of at least 3 mm. [. . . ] 9 then see and the pilot of the zone you want to time. If there are several zones functioning, , several times timer when you press pilot rotates (2. If you press you will go straight to the maximum time of 60 or 99 minutes. After a few seconds, this will be confirmed. When the time is up, the hob will beep and and the corresponding pilot light will flash. If you wish to change the time press and follow the above steps again. If you have used the timer in several zones, the display will show the time remaining for the zone closest to finishing. To see the time remaining press and choose the zone you want to check. Always take into account the details on the characteristics plate (1. 1) and the measurements of the unit into which the hob is going to be inserted (1. If you are not going to fit an oven beneath the hob, you must install a protective panel in accordance with the measure indicated (1. Stick the foam join along the outer edge of the hob to make it watertight (1. Turn the hob over and insert it into the hole (1. Colours: a) dark blue, b) light blue, c) brown, d) red, e) green - yellow Model (b). To connect to 220 – 240V~ connect the hob according to diagram 1. If it is different, replace the cable and make the connection according to diagram (1. 00 00 2 Use Clay, copper or stainless steel receptacles can be used with vitroceramic hobs. Aluminium receptacles are not recommended as they can stain the glass of the hob. You have various elements on which to place the receptacles. Choose the most suitable one depending on the size of the receptacle. 1) Note: The timer will switch off automatically if you take more than 10 minutes to set the time. Model (b): Once you have switched on a zone and selected the heat 1, 2, 3. [. . . ] The heat transmission is best when the base of the receptacle and the diameter of the cooking zone are the same size. When you have finished cooking, if you like you can leave the receptacle where it is to make use e n g l i s h of the residual heat accumulated. Use a lid whenever you can in order to reduce the heat lost through steam. electrical and electronic appliance waste management. [. . . ]