User manual BRANDT VF400JU1

[. . . ] For dishwashers that can be built-in, fitted with rear feet adjustment via two knurled knobs on the base of the machine, at the front, use a screwdriver, without exerting force, to finish the adjustments to avoid damaging the worktop. Protecting the worktop Glue the steam protector supplied with your machine underneath your worktop. Built-in appliance cup kit (available according to the model from After-Sales or the dealers) To assist in sliding your dishwasher (over rough or carpeted floors, etc. ), clip the little cups to all four feet. EN 31 Installing your dishwasher This dishwasher must operate with a wood panel. Facing the door To fit a door to match your units onto the dishwasher's door, use the installation template and the accessories supplied with your machine. [. . . ] Check that the seal is fitted and that the connection is tight. If necessary, you can alter the hose's direction. To do this, loosen the connection at the bottom left on the rear of the machine and swivel it as necessary. Fully tighten the connection again and check that there are no leaks. For dishwashers fitted with safety hoses: You must remove the protective cover (see the drawing opposite) to alter the hose's direction. To do this, loosen the two screws (end fitting T20), remove the protective cover, position the connection in the direction you wish and then replace the protective cover. When you are making a new installation, you must use a new hose to connect the machine to the water supply: you must not re-use the old hose. 0, 1 - 1 MPa EN 33 Installing your dishwasher Draining away the waste water Length of the drain hose: standard 1. 50m. If necessary, you can increase the length of the drain hose (4m max. ). In this case, check that the machine drains correctly. Connect the drain hose: - To a ventilated siphon For machines installed in columns, the height of the drain hose must not be higher than the top of the machine. NB: Pull the pipe gradually when installing it to avoid kinking it. - To a sink U-bend Remove the stopper form the U-bend. Remove the rubber stopper and, if necessary, add a collar. Electrical connection Mains voltage: 230V Fuse: 10A, 13A or 16A The socket outlet must be grounded to Earth. In all cases, the connection must comply with the standards in force in the country concerned, together with the supplementary regulations of the Electricity Authority. The machine must be switched off when the connection is made to the electrical circuit. We cannot be held liable for any damage caused by the faulty earthing of the machine. - Directly to your sink. Ensure that you hold your drain hose in place with the end connector to avoid flooding. If you have any doubts regarding the condition of your installation, do not hesitate to have it checked by a qualified electrician. [. . . ] Installation of the adjustable plinth on built-in appliances (depending on the model) AVAILABLE FROM THE AFTER-SALES DEPARTMENT UNDER REFERENCE: 32X0050 Safety instructions For your safety's sake, never leave your dishwasher's door fully open after use. If the machine is operating incorrectly, disconnect it from the electricity supply (remove the plug) or switch off the circuit involved and close the water supply tap. If your dishwasher is being installed on a carpeted floor, make sure to adjust the feet to leave a ventilation space under the machine Building in under a hob If your worktop is fitted with a built-in hob over your dishwasher, you must provide thermal insulation on top of the machine. [. . . ]